Replacement Left/Curb Side Leg for etrailer and Ram Hydraulic Jack - Square Tube - Bolt On - 12K lbs

Video Transcript for Review of etrailer Trailer Jack Left-Curb Side Leg - e63VV

Hi, everyone. Steve here with etrailer.com. Folks, today we're looking together at this replacement Left or Curbside Leg for the etrailer or Ram hydraulic jacks. Now folks, this is gonna be a bolt-on square to application, rated at 12,000 pounds. Now, like I said, this is the left side, or a curbside. You will need a right leg and also a hydraulic pump and power unit.

Those are sold separately. You can get them here to etrailer.com. I'll put them (indistinct) on the screen for you over here. Now this is gonna work with units that offer up to 3,200 PSI extension and 1500 PSI retraction pressures. Now it is a simple bolt-on application.

You got two of these seven and a half inch long by four inch tall brackets, both on the top and the bottom. And you can simply just bolt it on. And over here you've got your hydraulic hookup ports. That's for your hydraulic lines. The jack itself is four and a half by four and a half square tubing.

And as you can see, it's heavy duty black powder coated steel on that construction. So one, it's gonna be heavy duty and able to lift everything you need at those ratings. And two, you don't have to worry about rust or corrosion. As you can see, I've got some wedges down here on my foot plate. The foot plate is 10 by 10 square.

And this foot plate can pivot up or down pretty much, actually. That's why I had throw them wedges in there, so it doesn't tip over on me as I'm doing the video here with you today. So very heavy duty. I'm not gonna be able to show you that pivoting, but trust me, it does pivot pretty dang far. It's also gonna give you a great foot plate for whenever you're uneven surfaces, maybe soft ground, stuff like that. It's not gonna sink down as much as some of the smaller ones that are out there and stuff. Now the screw travel inside of here can travel 24 and a quarter inches. When this is fully retracted, I got a bracket height of 34 and seven eighth inches. And when it's fully extended, I got a height of 59 inches. The lift capacity is 12,000 pounds, so pretty impressive. The support capacity is 15,000 pounds. Well, folks, I think that we'll wrap it up for our quick look together at this etrailer Left Curbside Leg. Again, I'm Steven. Thanks much for your time. We would also love if you got some photos of this installed on your rig after you've done the installation, what it looks like so we can share that and just kind of see what you're doing with it. Also, we'd love to hear feedback from you, good or bad. What you like, what you don't like, what can we improve on. All that kind of stuff helps us and helps you get a better product as well. Have a good one.