Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
This item does not fit your vehicle
2010 Nissan Versa
These items fit your vehicle
2010 Nissan Versa
To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Perfect for light-duty towing, this custom, vehicle trailer hitch receiver features fully welded, gloss powder coated steel construction. Drawbar sold separately.
Features:
Specs:
At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it, and we've towed with it, so whatever your question, we can answer it.
California residents: click here
Thank you Sara W. Perfect fit for our FIT! Hollywood Bike Rack Fits Perfectly. Thank you
The rubber muffler hangers were a bit tricky to reinstall, not impossible, just tricky.
Routing the Hot wire for the trailer wiring is best done on a lift.
Mike L.
3/18/2026
The 12V feed for the wiring can be tricky without a lift, I like to use ramps.
Easy install on my Honda Fit to hold a bike rack. Install was straightforward, lowering the exhaust was much easier than I expected.
I was very pleased with the design, quality and specially the price. Instructions were detailed which I barely used since I am very mechanically inclined. I wanted to install a hitch on my small car to use a bike rack. My new hitch and bike rack look so nice!
The best part of doing business with etrailer is, I know I will find what I need when I go to their website. The Curt Trailer Hitch Receiver fit the Fit. Installation on the 2016 Fit was a challenge, especially compared to installation of the equivalent hitch receiver I installed on a 2008 Honda Fit, which I also bought from etrailer. Instructions suggested that I could remove the exhaust system, as required on the 2016, without special tools. I needed to buy a special tool and even with the special tool I was challenged. All the necessary hardware was included and the installed hitch receiver meets all expectations. I also purchased a wiring harness for the trailer. Again, installation on the 2016 Fit was a challenge, especially compared to the installation of the equivalent wiring harness I installed on a 2008 Honda Fit, which I also bought from etrailer. The 2008 wiring harness is a "plug-and-play" installation with no cutting and no splicing. The 2016 wiring harness requires cutting and splicing and running additional wire. The wiring harness purchased and the instructions supplied enabled me to execute the work successfully. The installed wiring harness meets all expectations.
The installation challenges are because of the Fit, not the Curt products.
Heather A.
9/22/2017
James,Thank you for your review. If you are looking for a wiring harness that does not require splicing into your existing wiring I recommend Item # 119250KIT. This Tekonsha wiring harness is not consider a plug and play application but the sensors on this wiring harness clamp onto your factory tail light wiring to detect current but you will still have to run the black power wire to the cars battery.
Helpful Links
Packaging and arrival was sturdy and quick following my order placement.
All hardware needed was included along with clear instructions.
I use it to carry bikes around and it has been dependable after one year. I expect more years of flawless service. Install was slightly difficult with the fishing wire. My tip to you is do not thread the whole shanks with wire, only a turn or two.
After doing extensive research on what trailer hitch to purchase for my 2015 Honda Fit, I decided on the Curt C11406. It turns out to be an Excellent choice! I Love the Hitch. It was Super easy to install and only took me 30 min. I did it without having to lift up the back end of my car. - Layout a tarp, have tools ready and at hand, pulling the rubber muffler hanger should be spray with soapy water and can be push off the hanger easier (Use gloves if you have them/makes it easier to push off hanger) (Definitely use a torque wrench to ensure proper tightness of bolts.) I also purchased the Curt Rubber Tube Cover C22271. Etrailer has great deals with fast shipping. I highly Recommend. Will be doing business again. Thanks Etrailer!
-GT California
Joshua B. was extremely helpful, I got my receiver in short time and it was a quality product. If I ever order another receiver, it will be a etrailer!
Gwendolyn Y.
6/22/2025
We think so too, William! Thanks for giving Joshua a shoutout. Also, happy to hear you love the hitch! What are your plans for the hitch?
Installed this on a 2015 Fit. It was the second hitch I've ever installed, and it was by far the easiest. Other than futzing with the muffler's rubber bushings, it was a piece of cake. It was fairly easy to remove the muffler from the bushings, but it was challenging to get the muffler reinstalled. I am sure it'd be easy with the proper tool or with a lift, but I had a tough time doing it lying under the car and with various hand tools. It is in a position where it's hard to get leverage.
I would estimate that it took me 40 minutes, start to finish. Much of that time was eaten up by getting he car jacked up and supported and screwing with the muffler. The actual install of the hitch took about 10 minutes. It was slightly awkward to do by myself, but I borrowed another reviewer's suggestion to use my jack to lift the hitch into place. No drilling was required, as promised.
Also I wanted to mention that while the manual says that you have to use a strap to support the hitch, it seems fine without it, at least with light loads. I've carried my bike on a hitch, and it does not seem to flex very much. I am not at all worried about it, although it might not be strong enough to support three or four bikes. I think it's a function of how this has to attach to the car. The upper and lower supports are separated vertically more than they are horizontally, so that's got to weaken the lateral support capability.
Great install instructions. Took the dog and I about an hour and a half start to finish with a little troubleshooting with dish soap. It has held up great, gets multiple bikes around town. A little wiggle between the hitch and the bike rack but I don’t think it’s the hitch’s fault.
100% satisfied. Great customer service, fast shipping. Great product. The prices are unbeatable. I won't buy from anyone else.
Dick D.
4/12/2018
It has been nothing but great. Thank you for taking time to follow up with me. I appreciate it.
Works well, and the video how-to was extremely helpful for an installation newbie like me!
Has performed great for us. Only use it to support a bicycle mount but it is very stable and secure. Especially like the angle that it lowers at to allow the hatch back door of the 2018 Honda FIT to open completely. That was not the case with our previous hitch/2010 Honda FIT combination.
I bought this for my 2020 Honda Fit for the sole purpose to haul mountain bikes. The hitch was easy to install with basic hand tools. It hold the weight of my ebike along with a friends just fine.
Thank God for y'alls video or else this venture would not have happened. I needed a tow hitch for my bike because the trunk mount I had was too sketchy. This product fit perfectly on my 2016 Honda Fit.
Little note: Curt's install video either didn't show or vehicle wasn't equipped like mine but I had a 3rd muffler mount further back. That was a doosy getting off. Didn't have a lot of room to screw in the nut above muffler so I had to take the rear passenger off to use the torque wrench. Other than that, I love it!!
Excellent product. The hitch, 5" adapter, cargo carrier. Easy to put together, all the parts were there. Very fast delivery. Kudos to Lisa and E. Trailer for above and beyond products and service. I have a small car and it was packed when I went camping alone. Now daughter and I are doing a 3 week trip in June. More stuff.
Fast delivery and I was able to install it myself, although a second person would have been helpful. The hardest part was removing the rubber insulators for the muffler but WD40 helped (along with a pry bar). The construction of the hitch is good and watching a video of the installation helped. I had no issues and I recommend this product.
Easy to fallow instructions, great design, and as always great customer service from etrailer. One thing I recomend is to google how to remove the rubber muffler isolator before you start the installation and you'll save some time.
I bought this Curt hitch for my move from ohio to oklahoma since it was cheaper then driving a truck and then tow my car. The instillation was fast once I got everything situated since I did not have access to a lift. Thank goodness I’m a small women. Took me about an hour to finish the install but that includes the prep time.
Nice hitch. Good directions. Installed in 30 minutes easy. Used silicon spray for muffler mounts.
I watched the video 3 times and found the hitch easy to put on once I got my dad to manhandle the exhaust clips. Small hitch for a small car. Looks good.
Well planned fitting. The box is good for lying on. One hour from UPS delivery to fitted without lifting the car.I think the trickiest part is removing the wires before threading the nuts on.
Product installed very easily and only took maybe 20 minutes, hardest part was undoing the rubber exhaust hangers.
Great product, super easy to install everything fits great even on the muffler side. Took the muffler off is the hardest part of the installation
Do you have a question about this Trailer Hitch?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Kate F.
3/4/2026
Install looks great Mark! I am glad we had the right fit for you so you can get out doing what you love! Do you have specific trail you like to ride? We have the Katy Trail here in Missouri and it is always loaded with riders when the weather is nice.