Video Transcript for Breaking Down the TorkLift Finishing Kit for Camper Tie-Down Systems

Hi, everybody. Andy here with etrailer.com and today we're gonna take a real quick look at this TorkLift Finishing Kit for your camper tie-downs. Now, this finishing kit is going to give you protection for your camper tie-down system when it is not in use. These vinyl caps are going to cover your front receivers to keep out dirt and grime, and these foam plugs are going to insert into the rear of your brackets to keep out dirt and grime. So let me go ahead and just give you some brief measurements here so you have an idea of the size of them. So looking at the length, or the width rather, both of those measurements are gonna be the same.

This is two inches by two inches, and then the depth we're sitting right about an inch and a half. So those are on the vinyl caps. And on our foam plugs, as you can see we're sitting right about an inch and three quarters by an inch and three quarters. And then the overall depth, we're sitting at about an inch and a half. So these are going to be a very fast and easy installation.

You're just going to remove your tie-down inserts and place these vinyl caps over your receivers and then insert these plugs into the back of your tie-down receiver openings. If you can't, for whatever reason, fit these into the back of your receivers, whether it's because it's just inaccessible or it might be a little bit closed off, you can just insert the foam plugs through the front of the receiver and use an insert to push this all the way to the rear or the back of your receiver bracket opening. So this kit includes everything that you see here. You're going to receive four receiver caps and four backing plugs along with a set of instructions to just go over the really simple and brief installation process. These are made here in the USA.

And that's gonna conclude our brief look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.