Most Popular Plastic for Freightliner Sprinter

Product was excellent and the installation videos on the website were invaluable!

Bought this to replace original bath fan (Maxxair) when the raising mechanism broke. I ordered it from etrailer on a Wednesday, and it was delivered on Friday....super fast delivery. Easy install, and I think we will really like it's features (i.e. 10 speed reversible fan, rain proof cover).

Fan arrived quickly and was an exact replacement for our Hail storm damaged unit. Thanks eTrailer!

Our hunt club has 2 pit blinds that are used for waterfowl hunting. Each blind is essentially a concrete box with walls, floor and top 4 inches thick and dimensions of 12'x5'x5'. Each blind is buried to a depth of 5 foot to where the top is flush with ground level. Access is through the top using 24 inch wide manhole lids that are made of high density plastic. The cooler air inside of the blinds clashing with warmer air absorbed by the concrete and manhole lids at ground level caused condensation that made the inside damp and smelly. We only hunt 3 months each year, so needed a vent solution for the other 9 months the blinds were not in use. We also needed something that could be powered by DC voltage from a solar panel due to the remote location. In July 2015 we installed each fan into a manhole cover and used water-tight conduit and electrical boxes to run the wiring from the solar panel to each fan. Great solution! Once enough daylight hits the solar panel the fan blades start moving and run constantly until sundown. Will see how long these things last but so far so good

Excellent, powerful fan & my second Maxx Fan purchase in total. Consistently great products. Shipping box was damaged & there were some smudges on the top of the fan, but... it's not like anyone is going to be looking at the top of it anyway & nothing inside was damaged, so all's well that ends well. Definitely a fan of the white top over the more popular "smoke" color for a smidge less heat absorbtion. Also glad that the manual fans continue to be offered as the remote-capable alternatives hardly seem worth the upcharge in situations where the fan is within reach.

After many months of fretting over cutting into the roof of my new van, and waiting for the rainy season to end, I found the installation very easy, and the operation is great. We're currently on a road trip, and the MaxxAir has made camping much more comfortable, and it even improves air circulation while driving with the vent open. it's very quiet at low speed and no leaks in even the heaviest rain.

Delivered as promised in fine shape. MaxxFan fit perfectly in existing 14X14 opening. Simple install and is functioning as designed.

This fan was great. I had an issue initially with the motherboard and the company replaced it ASAP at no charge. Really good customer service and an excellent fan!.

Perfect fit, easy to install, arrived super fast!

I'm glad there was this replacement cover, so I didn't have to redo the whole vent. It fit perfectly and your DIY video is perfect. It would be nice if the cover were sold with a strip of the rubber seal that goes around the metal vent base. My original strip has a big dent in it where the original hardware pushed down on it.

Product description, fitment, construction materials, size, all matched the website. Very good product for replacing your vent on a trailer. Excellent support and shipping from company.

Installed this vent into my Haulmark Transport 6'x12' enclosed trailer. Installation was easy, I cut a 14.25" x 14.25" inch hole between two crossmembers in the roof and dropped it in place. Because the roof on this enclosed trailer is so thin, I used a piece of 3/8" plywood so sandwich between the interior garnish and actual vent. I cut the same size hole into the plywood and left a 2" lip all around. I use 28 #8 x 5/8" stainless screws to hold it in place, pre-drilled with 1/8" bit. I then used roofing tar to seal the vent and put masking tape all around, leave 1" from the flange to ensure good coverage. I then removed the masking tape, leaving nice clean lines. Interior garnish is held in place by #8 x 3/8" galvanized screws. Huge kudos to etrailer for carrying such awesome products for great low prices and offering super cheap shipping to Canada!

Excellent fit and finish as orginal. I can trust etrailer as they always meet or exceed my expectations in product and service. Thank-you

The caps that I received were original replacement caps. Installation was fast with only two screws on each cap. Vents were close to the edge of the roof of my Airstream so I could replace them from the ladder. I was done in less than 30 minutes. The customer service was terrific and I got the caps in two days. With the new caps and gaskets, I am hopeful that our bathroom and shower will be drip-free.

Great follow up, part was exact. Thanks,Pete

I purchased two of these to replace the gas exhaust vents on my horse trailer. Everything fit perfectly. Easy to order and very fast shipping!

I installed this as a bathroom fan through the sidewall of my T@B teardrop camper. Works great.

The outside diameter is closer to 8". I will be sending it back.

Love the light...installed myself. Not the easiest install but well worth the effort. Would not hesitate to do again.

Works great! It's in the ceiling of our shower. It moves the moist air up and outside. The light in it gives us a well lit shower. Our shower is 36x36. We are satisfied. We recommend it!