Summer Starts Here - Save up to 70%
# 1
Curt A16 5th Wheel Trailer Hitch for Chevy/GMC Towing Prep Package - Dual Jaw - 16,000 lbs
Just installed this CURT 16K ~5th wheel hitch into our new 2017 GMC truck. It took about an hour and it would have been nice if the directions would have told you what height each set of holes would produce. I'd recomend using some marine grease on the four puck joints prior to trying to lock them in. I really like this new hitch puck truck system over the Reese hitch with the bed mounted bars. I'd highly recommend this hitch if you have the factory GMC /Chevrolet puck system. The e trailer online help was truly appreciated as it steered me to the proper hitch for our new truck.
Very easy install. Looks great. Functions perfect. Easy hook up to fifth wheel. Perfect fit for my 2017 gmc HD Denali 3/4 ton with factory installed fifth wheel plate. Love it thanks. Just what I was looking for. Better than paying 1,000 dollars at chevy dealer for them to order.
# 2
Curt A16 5th Wheel Trailer Hitch w/ R16 Slider - Dual Jaw - 16,000 lbs
The Curt A16 5th wheel w/ R16 slider is a great looking hitch. I received the hitch on May 11, 2023, replacing an older Reese 15K hitch with a slider lock bar. It was easy to finish the assembly and install. I immediately took my fifth wheel out, using the new hitch with the dual jaw locking system. The ride was amazing. The RV, which weighs approximately 10,000 pounds, loaded, did not buck or rattle, and responded perfectly to the turns, acceleration and deceleration with no issue. It was if there was nothing behind me. The only issue with the Curt A16 is the height. At its lowest setting, the nose of the trailer was up too high. However, by raising the tongue of the RV to its highest setting, I was able to remedy most of that issue. I am looking forward to my trips this year with the new hitch!
So far it works great. Only pulled in a short distance and backed it up into my driveway. Make sure you have help lifting this. Very Very heavy. Directions were average but got the job done. Love the extra turning radius on my short bed F250. Make sure all the parts are there. The handle to release the king pin off the hitch was not in the packaging. The box that the hitch and slide came in were all in tacked and looked good. Emailed etrailer and within a few hours they sent were processing the order for the handle. Arrived in 2 days. That's great customer service.
# 3
Curt A16 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
I purchased both the Curt A16 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs - C16120, and Reese Pull Pin Lock Plates for 5th Wheel Trailer Hitches - Qty 4 - RP58093 for my F350 SD 4X4 Crew Cab Long Bed. I'm pulling a 30' Retro 5th. Wheel and at times I pull my tandem axle UTV Trailer (Double Trailers) . I already had the rails installed in my truck, this fit right in and I used the new Pins and Lock Plates for securing to truck. I have pulled all over from South Dakota and the Northwest. The Hitch has performed Flawlessly. No bucking, nor clunking. Very quiet and smooth ride. I would recommend this set up to anyone for convenience of Hook up and Disconnect, Excellent towing, quiet, and the security of the lock pins. I use Disc locks to prevent access for bolt cutters.
I was fully expecting a hitch in excess of 100 pounds to show up in a destroyed box. This did not. They had taken the Time and effort to cover the box with an additional layer of cardboard and it must have had a million staples in it. It was almost comical, you will need a crowbar or large screwdriver to get it open. However, when I did finally get the package open I found a perfectly un scratched hitch with no missing parts. I have not pulled with the hitch yet but , it does look like it is going to perform great. I'm using this in a 2006 ram 2500 4x4 short bed pulling a 2015 forest river Salem and it allows 91 degrees of turning due to the clipped corners on the front cap of the trailer. I will be curious to see how long the rubber isolators last before needing replaced and if they are readily available. Also the curt sticker on the hitch was peeling off when I took it out of the box, would be nice to get that replaced.
# 4
Curt E16 5th Wheel Trailer Hitch - Slide Bar Jaw - 16,000 lbs
After ordering rails for a fifth wheel that I had in an older truck, I was told the rails I ordered would work with my fifth wheel, however after installing the front rail, the fifth wheel would not work with the rails ordered. I ended up ordering a new fifth wheel plate. That was easier than removing the frame brackets I had already installed. It appears that there was a mis communication between the person I talked to with etrailer. Instead of a 1/2 day install it took a day and a half plus wait time for the fifth wheel to get to my address. However once installed it appears to be good.
The hitch worked great. Reason for the 2 stars is the package got delayed twice in transit and I had to reschedule the pickup of my fifth wheel. When I also received the package the main crossmember bar was bent at the mounting point. Luckily I was able to bend it back but UPS needs to get there act together.
# 5
Curt E16 5th Wheel Trailer Hitch for Chevy/GMC Towing Prep Package - Slide Bar Jaw - 16,000 lbs
Checked around the local truck shops in my area and everybody was between 1200 and 1900 for hitches and then installation. Nobody wanted to install one in my factory package, everybody wanted to drill more holes. One call to retailer and I had a factory correct installment fifth wheel hitch for a third the price of the local guys. Awesome product and easy installation.
it worked as it was to.work
# 6
Reese 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
This product gets a three based on shipping condition only. etrailer customer service and shipping time was excellent as usual. The shipment arrived 2 days after the order was placed, as promised. However, as others have noted, the product packing is poor. The boxes arrived with significant damage resulting in cosmetic damage to several parts. I haven't put the hitch to use yet but I am assuming it will work correctly. I will leave a followup after I use it.
The hitch arrived nicely packed in two boxes. Very easy to assemble and install on my existing bed rails. I took the RV out for a first run with the hitch, and it performed as advertised. It was a no fuss transaction and the hitch arrived on-time!
What our customers are saying:
"Quick processing, and delivery. reasonably priced very satisfied"