Most Popular Aero Bars for 2021 Chevrolet Equinox

When we made our Chevy Equinox into our RV towed car we quickly found out we needed help from etrailer.com. From ebrakes and a baseplate to the tow bar and naked rook Rhino roof rack they were great to work with. I did all of the installation and most of it was easy. Some of it was harder so we relied on etrailer's great videos for things like installing the brake system and base plate. Everything is working great so kudos to etrailer!

Seem easy to use. Good material

Excellent system. Little to no wind noise. Measurements to mount the rear bar to the 2020 Equinox are incorrect in the instructions but easy to adjust to an exact fit.

The roof bars are awesome. I use them with a roof top cargo carrier. They are very easy to put on and off the 2017 Equinox.

Very satisfied. My roof rack was shipped fast, packed well, fits perfectly and looks great on my 2017 Equinox. etrailer stands out as a great resource for excellent products, technical information, service and support.

Great product, great service from etrailer. The instructions were very clear and I had it installed on my car in under an hour. It's very solid

It arrived in good shape fits well, in the back there seems to be a bit of gap on the rubber pads, probably its supposed to be like that, I don't think it'll affect the rack in any way. I shaked it like a gorilla, seems sturdy. The only downside would be that me being from Canada, I didn't know it's in US dollars, so I thought they're ~450$, and I got a surprise withdrawal of ~720$, but that's ob me, should've researched better. Maybe in the future there could be some sort of big attention sign for dummies like me? :))

Disappointed. The clamp covers are poorly designed, they don’t stay in place once the clamps are tightened. Although this product says it fits my vehicle (2022 Chevy Equinox), I was forced to place the front cross bar further back than I wanted to because the clamps wouldn’t secure properly where the side rails attach to the roof. The rubber inserts provided to reduce wind noise just loosely fit into the slot on the underneath of the cross bars; doesn’t seem like they’re going to be any benefit.

Worked as designed. Some measurement needed to cut and install seal between attachment brackets, and little trial and error to center/balance the bar across both points (just as one would with a cargo box).

I've had these on my car for a year now. They are decent for the money and I think they look pretty good too. One very weak point is the plastic end caps. They snap on and are flimsy. I lost one in short order and broke another one sliding a sheet of plywood over it. It would not be hard for them to design a better cap that is fastened better to the rails. I 3D printed new ones that work great and installed with a screw.

Rack looks sturdy. For my 2017 vw Alltrack the rear bar could be replaced for a shorter. On my side picture that is as far back the bar will go (item ja7975). Which it worked out for this application if you want the bar further aft a shorter bar will be needed. The front fit well within it’s range. The car tapers towards the back so back bar is shorter. I also dont like how VW put a notch on the bottom rail. It looks like the straps will be easy to cut with a bolt cutter.