Most Popular Locks Not Included for 2016 Mercedes-Benz Sprinter 2500

This is the 2nd time I have purchased this bike rack and it a good fit for the Sprinter van. The rack is sturdy and pretty easy to load while not taking up a lot of space. It does take a couple of days to install due to drying times on the adhesives for the rails that mount to the door.

The Thule Elite Van XT2 Bike Rack is just what I expected but the install instructions leave something to be desired. Nothing but pictures trying to describe the install. Even a few poorly worded sentences would have been helpful in some places. I have seen this noted in other reviews and [online]. Otherwise a quality product and I have been able to integrate it with my Kuat swing arm and bike rack that we were already using. I wanted to be able to add a 3rd bike to our setup without extending the length and still be able to open the rear doors without removing a bike. This all worked out with just a little modification. I did move the Thule bike rail install point 1.5" above the center install position to allow clearance over my wife's ebike. See photos.

Very easy to use (once you do it a couple of times). I have ebikes and they handled the weight (48lbs each). The biggest issue I have with this racking system is wishing there was a left and right models of it...unless I didn't see one when ordering.

Basically, bolt it to your rack and you're ready to go. Easy to use once you do it a few times. My only complaint is for $200 they could throw in a lock core. Also, this etrailer response is incorrect, it is actually pretty simple to swap the operation of the rack to work on the driver's side (without having your bike face the wrong direction). Two plastic locks hold the main assembly together, unlock, take the hook out and put in the other way. The loop thing at the front is held in by one allen bolt on the bottom; take it out, swap the direction. Finally, the rear tire strap slides out the back; reverse it and slide it on. It takes longer to put the carrier on /off your rack than to swap the direction (not more than 10 minutes).

This is a great way to transport a bike. Just bolt the dirtbag to a surface and attach the fork. I have mine mounted in the back of our minivan and regularly transport my mountain bike inside the van. The dirtbag comes in sizes to fit most fork configurations. I have a through axle for my tandem bike, 100mm for my mountain bike, and now the 110mm for my 29+ mountain bike. They all have the same hole pattern so I just swap them out depending on which bike I am transporting.

That mount is the perfect solution for us. Our previous bikes had the older skewer axle mount, so I had to re-drill the base to match up with holes in bed rail. FantomWorks of Velocity TV fame fabricated and installed threaded plates under the bedrail so it made the swap quite easy! Thanks!!!!!

Neat design. That's the only positive. Shows up in a million pieces. Surface rust on some of it already. Need a hammer to use "quick release" pins to pivot. 1 1/4" adapter is not long enough for either car I tried, unless your hitch sticks out PAST your bumper don't even bother. Had to trim 2" section of rack to make it fit hitch. Had to grease pivot section because rough surface finish would NOT allow rack to pivot. If I didn't need it (and didn't spend 2 hours assembling) I would have sent it back. Worst bike rack I've bought since a K-mart contraption 30 years ago.

The bike rack is made for bikes with no fender, our bikes have fenders and a rack over the back tire. We added some padding for the back tire so the rack doesn't get scratched, it works just fine our bikes are secure.

One Year Later – Still Going Strong I’ve owned this rack for a year now, and I couldn’t be happier. It securely holds all 4 of my bikes, even on longer road trips, with no shifting or wobble. One of my favorite features is the ability to tilt the rack away from the vehicle—even when it's fully loaded. That’s a huge convenience and makes it super practical for daily use. Durable, easy to use, and thoughtfully designed. Highly recommend if you're looking for a reliable 4-bike solution.

This bike rack has worked well for us. We have a Jeep Wrangler, with the spare tire on the back of the tailgate, and needed a rack that would hold the bikes in a trailer hitch, and swing away so we could easily access the rear storage of the jeep. This has worked out perfectly! I did have to use a hitch extender to clear the rear tire, but that was expected. The rack works well, holds the bikes as expected, and is easy to use, and get on and off the vehicle. I am very satisfied!

I was sent additional mounting materials that don't correspond with my hitch or my bike rack. See the photo below. Are these materials for my Swagman STC2 Bike Rack Item #S64670?

Very stable and simple to use bike rack that works great with my road bike AND with my 29" Big Rippers. It makes loading and unloading the bikes a snap and they are safe and secure for traveling once loaded and secured. I have already logged over a thousand miles hauling bicycles with this rack and highly recommend it. I am a big fan of Yakima roof racks but, honestly, wish I would have went with this setup for my bikes from the beginning.