# 1
LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Red Lens
Although this light looks the same, it is not. The hole pattern for mounting is different, and when I twisted the wires together, it did not light when turning on the lights. It is in still new condition and I will return it.
Exact replacement for Jayco running lights.
# 2
Optronics Dual Bulb Trailer Clearance and Side Marker Light - Incandescent - Oval - Red Lens
Great replacement, looks like the vintage lights on the trailer.
After working on the old lights on my camper numerous times just prior to leaving on a trip and while traveling, I decided it was time to replace all of the lights. I purchased two new tail/brake lights, and four new side markers. The total price including shipping was just over $28 (I should have done this a long time ago). The lights arrived within 3 days of being ordered, and I was able to install them fairly quickly. I am so happy that I now have all six lights working perfectly, and shouldn't have to worry about them for a long time
# 3
LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Oval - Red Lens
The lights I ordered were a oerfect replacement for my rv..
# 4
Low Profile LED RV Light w/ Reflector - Brake, Tail, Turn - Submersible - Oval - Red
Etrailer sent in good working order and their videos of their products are very helpful for installation.
Perfect replacement fit on my Nexus Triumph 32TCS super C motor hime.
# 5
Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1
Quite easy to install and fit my Coachman Freelander perfectly. The prior ones were not sealed, filled with water, and blew the fuse fuse. Beware of the cheaper version on Amazon as they have the same poor seal problem as the original lights which died after <5 years.
Command Triple LED Tail Light Review They work great once they are installed. I have 2002 Gulf Stream Ultra on a Ford E450 Frame. The problem is the actual installation. Command does not include install instructions. What may needed if converting from incandescent bulb to a LED system is a 12 Volt 50 Watt 6 Ohm resistor. Installing a resistor parallel between the Brake/signal and Common wire will be necessary to overcome the hyper-flasher bulb out detection system. This high power resistor needs to be mounted on a metal surface to help disapate the heat created. In my case, I mounted the resistor to 3/4 metal pipe banding. The resistor was suspended so that is would have great air flow. Furthermore, size of the light should be slightly larger than 14 w x 6 7/8 . In my case the tail light was not big enough to cover the old light screw holes. I made this work by centering the light and using lap sealant as a finishing water proof bead. After a long road trip and many signal turns and brake presses the tail lights do look and work great.
# 6
LED Trailer Light w/ Reflector - Brake, Turn, Tail - Passenger Side - Oval - Red
The products seem well built. I replaced originals on 5th wheel RV to match new clearance lights. Larger and brighter than the original lights. I would rate it a 5 star if the product included screws and gaskets to prevent water intrusion.
They were very knowledgeable of what I needed and part was delivered very quickly.
What our customers are saying:
"I can't believe how super fast you filled and delivered my order last Sunday! I got the stuff in Tuesday. How fast is that?!!!! I sure needed that roof vent top in a hurry. I had plans to haul horses the next day that I was sure I would have to cancel because of the rain and the 14"X14" hole in the top of my horse trailer tack area. I've emailed all my buddies your site address! Thanks!!!! Ruth"