Most Popular Non-Submersible Lights for 2014 Winnebago View Motorhome

Although this light looks the same, it is not. The hole pattern for mounting is different, and when I twisted the wires together, it did not light when turning on the lights. It is in still new condition and I will return it.

Exact replacement for Jayco running lights.

Great replacement, looks like the vintage lights on the trailer.

After working on the old lights on my camper numerous times just prior to leaving on a trip and while traveling, I decided it was time to replace all of the lights. I purchased two new tail/brake lights, and four new side markers. The total price including shipping was just over $28 (I should have done this a long time ago). The lights arrived within 3 days of being ordered, and I was able to install them fairly quickly. I am so happy that I now have all six lights working perfectly, and shouldn't have to worry about them for a long time

The lights I ordered were a oerfect replacement for my rv..

The nuts fit perfectly on the Morryde wet bolts, the clearance lights are the exact match for our Jayco Eagl, I like to keep a replacement on hand when 1 burns out.

I'm not sure I saw it in the listing, but these are in fact Command brand lights - exactly what Jayco uses on their trailers. I replaced almost all of my lights this year during a water damage repair (might as well right?). These were super easy install and being the same brand, used the same holes to mount back up. I elected to use wire nuts with them as opposed to the clamp conectors Jayco uses from the factory. Wire nuts worked great for them.

Quite easy to install and fit my Coachman Freelander perfectly. The prior ones were not sealed, filled with water, and blew the fuse fuse. Beware of the cheaper version on Amazon as they have the same poor seal problem as the original lights which died after <5 years.

Command Triple LED Tail Light Review They work great once they are installed. I have 2002 Gulf Stream Ultra on a Ford E450 Frame. The problem is the actual installation. Command does not include install instructions. What may needed if converting from incandescent bulb to a LED system is a 12 Volt 50 Watt 6 Ohm resistor. Installing a resistor parallel between the Brake/signal and Common wire will be necessary to overcome the hyper-flasher bulb out detection system. This high power resistor needs to be mounted on a metal surface to help disapate the heat created. In my case, I mounted the resistor to 3/4 metal pipe banding. The resistor was suspended so that is would have great air flow. Furthermore, size of the light should be slightly larger than 14 w x 6 7/8 . In my case the tail light was not big enough to cover the old light screw holes. I made this work by centering the light and using lap sealant as a finishing water proof bead. After a long road trip and many signal turns and brake presses the tail lights do look and work great.

The products seem well built. I replaced originals on 5th wheel RV to match new clearance lights. Larger and brighter than the original lights. I would rate it a 5 star if the product included screws and gaskets to prevent water intrusion.

They were very knowledgeable of what I needed and part was delivered very quickly.

These were really easy to install. I found that I needed more markers on the side of our 5th wheel trailer (44') I actually posted a few videos of people turning into our lane thinking they had passed the trailer. Connected to the rear and front marker lights and I have had no problems since.

Rather late in being delivered, but I wasn't in a hurry. Have not yet installed them. I would definitely order from etrailer.com again.