Most Popular - 4 Inch for 2008 Mercedes-Benz M-Class

To be honest, I use it upside down. I needed a hitch with rise, but none were available at time of purchase, and yours, inverted, works perfectly! The welds are regularly checked and remain all secure. It's a good hitch.

Working in the sand and grass of my driveway my wife and I installed our new etrailer receiver hitch. Great fit and finish! Went right on as described in the online guide. Hitch required a spacer washer on top back bolt attachment point. Taped it on so it would not move while lifting in place and it stayed right there! Used a car jack to raise up and hold the hitch into the underside of the trunk tighten the bolts and reattached the tail pipe done. Now we can pull our Sunfish Sailboat any where the car will go.

Fits our VW Touareg perfectly and allows us to tow a variety of things now. As can be seen in the pictures the hitch has a +5-inch gap between the bumper and the vertical adjustment pillar and the trailer itself is out further so there's enough room to get to the rear hatch and maneuver the vehicle/trailer.

I needed a hitch that I could haul my work trailer with and still drop the tailgate without dropping the trailer. I looked on etrailer and found one that would work barely but decided to call etrailer and see if anyone had any ideas. Steve answered and looked after I told him my requirements and came up with this. This has a longer distance from ball to pin by a few inches compared to the one I found so my tailgate will still drop even if I’m at an angle to my trailer or on a hill. Also with the adjustable height it’s great. Awesome hitch. Solid for a good price. ??

Love these. This is my third one. Wouldnt pull a trailer with anything else. Trannys are expensive.

As a full-time RVer, e-shopping is very important for us. etrailer was the right place to shop. Right product, delivered on-time for a great price. You beat the local discount RV store by $25 including shipping. At the same time, I had another outfit send me a clearly inferior product to the one they displayed. Said they would e-mail a pre-paid shipping label for the return (didn't) and tried to put the blame on Amazon. Thanks etrailer for a great experience !

I needed the dropped ball for my motorhome to tow my Jeep. More importantly I needed the long shaft into the receiver for a device that bolted onto the shaft. This hitch worked perfectly in all regards. High quality and fits perfectly.

Product was shipped well packaged in a box to avoid damage. Perfect height and length for my F150 front receiver. This should make moving my trailer in tight spaces easier.

I needed an extended ball mount for my new Jeep in order for my utility trailer tongue to clear the rear mounted spare tire. Item is as described on the web site and was received earlier than expected. etrailer has great customer service and is my number one go to place for towing and trailer supplies.

Overall, I have to say that I am satisfied although not particularily impressed. The finish on the ball mount is mediocre ... there are several spots where the paint is chipped off for instance. It was received today and installed today with no use yet the pictures show the areas in question. You can tell by the label installation that someone who really didn't care rushed the operation. It also fit considerably looser than the Reese bar that I removed. I had to apply several turns of duct tape around the tube to make it as snug as the original. As I said, it'll do fine, just not impressed.