# 1
Adapter 4-Pole to 7-Pole and 4-Pole
Really nice trailer wiring adapter. Very easy install. Takes about 30 minutes with all the tools needed. Drill, 7/64 bit for pilot holes to mount the bracket, flat blade screwdriver and 11/32 nut driver and two #10 self tapping metal screws with locking split washers and a couple zip ties to tidy up the wiring harness.
This Brake Controller works great ! With a little pre planning and watching some videos I was able to install this on my ‘99 Ford Expedition. No knee banging or awkward reaching to set the controller the dial is right on the dash panel. Training and dialing the unit in was a breeze and it gives me consistent braking as needed.
# 2
Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
Çable good but after putting new 7way plug on truck cable wire colors did not match etrailers picture
7 pin connector separated from cable. I was expecting that "Molded Cable" meant that the connector was fused to the cable insulation but instead, the two separated almost immediately after I installed it. It still works fine as the wires are connected securely inside the connector but with the outer covering pulled out like this, I don't think it will last very long.
# 3
Hopkins Heavy-Duty Trailer Coiled Wire Adapter for 7-Way to 4-Wire Flat
Good quality product
This item was shipped very rapidly
# 4
Hopkins Endurance Multi-Tow 7-, 5- and 4-Way Flat Trailer Connector - Vehicle End - Ergonomic Design
Installed the Hopkins muti-tow 7, 5, and 4 way flat connector this morning. I ripped the original connector that was attached to the bottom of the hitch receiver off when I was 4-wheeling into the Doll House campgrounds in the Maze District of Canyonlands a month ago. So, I cut a hole in the bumper and mounted the new Hopkins connector, cut off the old broken connector mounting bracket, and connected the factory wiring to the new Hopkins device. Hopkins product installed easily, looks great, is now out of the way, and has the flexibility of multiple trailer connectors when required. I am pleased with the product. Attached is a photo.
Exactly what we had been looking for. Now I can hook up multiple trailers with different connectors and all the electrics on each trailer works. I mounted mine directly to the receiver hitch frame. The biggest challenge for us was routing the backup wire from the taillight housing, through the body of the truck to the connector. the rest went together fairly easily. Seems to be pretty solid and looks much better than the loose pigtail connector it replaced.
# 5
Hopkins Endurance Multi-Tow Trailer Connector Adapter - 7-Way to 6-Way, 5-Way or 4-Way
My '92 GMC Sierra had a 6-pin trailer harness connector and I'm going to be pulling a pop-up camper in a few weeks that has a 7-pin connector. I originally ordered a 47435 6-Pole to 7-Pole Trailer Wiring Adapter. After thinking about it for a day I changed my mind and ordered a HM48470 Hopkins Endurance Multi-tow 7-way, 5 & 4-wire Flat Connector to mount in the bumper and a HM47570 Hopkins Endurance Multi-tow Connect Adapter - 7-way To 6-way, 5-way and 4-way. The HM48470 will allow me to pull the pop-up as well as giving me the 4-wire flat connector that I need for my boat trailer. I bought the HM47570 adapter just to cover all the trailer wiring needs I might run into. I really like the fact that the 47570 adapter has the quick change plug to cover both wiring arrangements for 6-pin trailer connectors. I placed the original order Saturday evening and the second order Sunday afternoon. Monday morning, I called etrailer.com to try to cancel the first order and was told that both orders were already boxed and on the way the shipper. I had no idea that they had people there to pull and box orders on the weekend. I asked about returning the first order when it arrived and was told by Helen M that it would be no problem at all. I have been extremely pleased with my purchase experience with etrailer.com. Everyone I spoke with there was very knowledgeable and I will not hesitate to go directly to them for my trailer and towing needs in the future.
I needed an adapter for my electrical towing harness so the that I could use a 5-Way connector on my 7-WAY plug. On line, I found and ordered Item No. HM47570 "HOPKINS ENDURANCE MULTI-TOW CONNECTOR ADAPTER - 7-WAY to 6-WAY, 5-WAY or 4-WAY." When I received the product, I was really stoked, it was exactly what I needed and what I had been looking for! I tried it on for "size" as you might say and it's going to work like a charm. I will send some photos later when I'm done with the installation! No time right now. . this coming weekend! Photo 1&2 my connector; Photo 3&4 the new HM47570; Photo 5,6,&8 the light bar I wanted to install and the completed project. Thanks a bunch!
# 6
Hopkins Multi-Tow Trailer Connector Adapter - 7-Way to 5-Wire Flat/4-Wire Flat and 12-V Power Socket
Good solid unit that I expect to last a lifetime. I purchased this unit primarily to provide a charging port for a float charger. The idea being that if I forget about it or if someone else drives my truck and is unaware that it is connected, it will easily disconnect when the vehicle is driven away.
Perfect! I use the 4 flat for my boat trailer lights and the +12v I've wired to charge the boat battery as I drive to and from where ever I'm fishing; brilliant!
# 7
Adapter 7 Pole to 4 Pole with Tester and Cover
I have ordered several adapters and complete trailer wiring harnesses from Etrailer. All have been top quality. I have saved a lot of money on the plug and play trailer harnesses. Several hundred dollars when they are factory installed, less than $75 from Etrailer.
ETrailer had exactly what I wanted at a fair price. Website was easy to navigate and purchasing was simple. Shipping was fast and I was kept notified right up to when I received my order.
# 8
Adapter 4 Pole to 6 Pole and 4 Pole Trailer Wiring Adapter
eTrailer is a great company that sells good products at a reasonable price. In addition, they are very helpful in selecting products and providing post sale support. As for the product... it’s just what I was looking for. Perfect!
This adapter really cleaned up the installation and connected directly to the wiring harness. Maybe added an additional 20 mins to install this adapter but totally worth the time and money.
# 9
Hopkins Endurance Quick-Fix Replacement 4-Way Flat Trailer Connector w LED Test Lights - Trailer End
Nice product & good value imo--it's very beefy and appears to be heavy duty---I know these are supposed to be temporary---that said this one replaced a Reese connector connector exact same style w/LEDs that was almost 17 years old before it failed--hopefully this lasts even close to that amount of time--I don't use this trailer daily usually not even weekly---so maybe with commercial trailer use this connector isn't for you..... It's my considered opinion that many of the fails are the result of a lousy install or someone disconnecting by pulling on the harness INSTEAD of grabbing the connector either way this gets an A+ from me
This is perfect. I needed an easy way to change the connector on the trailer I'm working on. It was an old pop up camper with an 8 pin connector mounted on the frame. but I only needed a 4 after rewiring it. So, out with the old and in with the new! Plus it's really easy to connect all the wires. Picture is not of the new connector but of the whole project I'm working on. I've since mounted all the running lights, tail lights etc.
# 10
Quick Fix (TM) 4 Pole Flat Car and Trailer Ends
Handy to have around these parts. all good. Good instructions, youtube films with installation guides and prompt delivery. Good product range as well
Always a great experience
# 11
Hopkins Endurance 4-Way Flat Trailer Connector - Trailer End - Ergonomic Design
I rewired my light bar for my boat trailer with the items I purchased. Before I built the the light bar, every time I used my boat trailer I would waste valuable sailing or fishing time repairing faulty lights. The do not last long when you submerge them in salt water. This light bar now version 3.0 have given little trouble over the years
Great product. Works well when I had a broken connection on my 4 way plug end on my light-up hitch cover I bought from y'all a while back. Always a happy customer. Thanks, George.
# 12
Hopkins Endurance 6-Way Trailer Connector Socket - Vehicle End - Ergonomic Design
The stuff not here
Very difficult to make the wiring connections, I was afraid I’d have problems on down the road so, I took it out of circuit and threw it away
# 13
Hopkins Endurance Easy-Pull 4-Flat Extension w/ 2 Grip Rings - Vehicle and Trailer Ends - 48"
I purchased the Easy-Pull extension along with the 7 to 4 pin adapter a few years ago. I was very happy with it, but I had them stored outside the entire time on my hitch through Pennsylvania winters and summers. That took its toll on it and the connection pulled apart. That did not deter me from reordering the exact same product replacement. If I keep it stored outside again, I will keep it shielded from the elements.
Very fast shipping and customer service is great
# 14
Hopkins Endurance, Flex-Coil Trailer Connector Adapter - 7-Way to 5-Way or 4-Way Flat with Nite-Glow
Nice product and excellent support from etrailer when I thought it wouldn't work with my 4 pole setup. Thanks Patrick
Great product. We used it with our Toyota 4 runner to tow our boat. Since the Toyota 4 runner electrical plug in is so far behind the rear bumper, we needed this extension in order for there not to be any issues with the wiring for boat trailer to become disconnected from being too short. The cord being coiled allows the extension to be as long as needed without possibly being drug on the ground.
# 15
Hopkins Endurance 5-Way Flat Trailer Connector - Trailer End - Ergonomic Design
The product arrived in a timely manner and undamaged. I have not used this 5 pole adapter yet, but the 4 pole adapter I previously bought from etrailer years ago is still working great. I have no reason to doubt that this adapter will function equally well. I appreciate the good products and customer service from Etrailer.
I needed the extra wire to run for multi-led lights mounted underneath the steps at the rear of my trailer, when in reverse trailering. This connector seems heavier-duty compared to many on the market and so far is still working well after a year or more. As with most products from etrailer, I haven't been let down yet. Here's a real special GOTCHA moment I had recently; My trailer jack stand, which I had purchased from my well-known and popular local trailer company to replace my original had rusted to pieces. I needed a replacement quickly and trusted I'd get a decent product and price as had been the norm over many years. Anyway, I purchased the new jack and wheel and brought them home to install myself. Upon taking the jack out of the bag it came in, I noticed a sticker from etrailer, yea. Before installing I went online, saw that my jack was less than half the cost I'd just paid, and realized I should have purchased the jack when I had originally shopped online at the start of this replacement process. I could have returned my over-priced items but decided I didn't have the time due to procrastination. I decided they could keep their extra profit on this purchase but I won't get fooled again and my local shop has lost my trust.
# 16
Hopkins 7-Way RV Style Trailer Connector w/ LED Test Lights - Trailer End
Easy to wire and very convenient indicator lights. Only thing to be aware of is the power light will stay lit if your trailer has a battery (e.g. a camper) and so it will put a small drain on it. Not really consequential if you're properly taking care of your battery anyway (disconnect or trickle charge when not in use).
This connecter was very easy to install, and the LED display is a great addition.
# 17
6-Pole Square Trailer Wiring Connector Kit (Car and Trailer Ends)
Item wasn't going to work. Would have to pay return shipping. May have to sell on Ebay to try to get some of my money back. etrailer should provide a return label.
Bullet-proof connector, if not the most elegant. Used in my case for custom "adventurization" wiring on my 2007 BMW F800ST motorcycle, now just road tested this late summer - early fall 2017 on a three month, 18,000 mile loop out of Chicago through the Arctic & Pacific Northwest, including the Dempster & Dalton Highways. Had a custom wiring harness that had to be able to be removed in order to get at the engine, hence the need for the connectors. A few photos should be attached.
# 18
Hopkins Endurance Quick-Fix Replacement 4-Way Flat Trailer Connector w LED Test Lights - Vehicle End
I recently had a need for the Hopkins Endurance Quick-Fix Replacement 4-Way Flat Trailer Connector w LED Test Lights - Vehicle End - HM48190 to replace the faulty one on my van. It was easy to find what I needed on the site and the price was comparable to other sites I had visited. I decided to go with etrailer because I had previously ordered the hitch through them. I appreciated the fact that an email was sent out confirming that they received the order as well as a follow-up email telling me that the part was shipped along with providing the tracking number. The installation of the part was easy and took no time to complete. Overall it was a fine experience and if I need to order anything in the future, I will be sure to come back and order from etrailer.
Great product. Easy to install
What our customers are saying:
"Your internet site is very well organized and easy to use...My order was shipped very promptly and included everything I ordered...All in all this was a simple procedure for what can be a complicated order. I would use your company again or recommend you to others. Your selection was broad and your prices fair."