How to Wire a Lippert Solera Smart Arm to a Rocker Switch
Updated 11/01/2024 | Published 10/31/2024
Question:
How do I wire an existing rocker switch to a solar smart arm and not power the arm switches on the arm?
asked by: Art R
0
Expert Reply:
Art, to wire your Solera Smart Arm Electric RV Awning Arm # LC759404 to a rocker switch, you'd just need to wire that red wire to a 15A fuse, and then to the positive post on your battery. The Smart Arm Control also has a red wire that runs to a 15A fuse and then to the battery.
expert reply by:
Bryce D
0
Continue Researching
- Shop: Replacement Short Arm Assembly for RV Awnings - 63" Long - Black - Qty 1
- Search Results: solera smart arm
- Q&A: How to Wire Solera Smart Arm 12V Power RV Awning
- Q&A: Wiring Diagram for Solera Smart Arm 12V Power RV Awning Conversion Kit
- Shop: Replacement Switch Kit for Solera Power RV Awnings - Black
- Shop: Wind Sensor for Solera Smart Arm 12V Power RV Awnings
- Shop: Replacement CAN Bus Data Cable for Lippert Ground Control or OneControl Leveling System - 20 Ft
- Video: Review of Lippert Replacement CAN Bus Data Cable For Ground Control Or OneControl - LC45ED
Art R.
10/31/2024
The rocker switch all ready has power and works out to the upper wall where the arm mount is mounted. I am just trying to get the arm to work from inside not the out side control.
Bryce D.
11/1/2024