Are Relays Needed to Activate Tow Package Wiring in 2012 Suzuki Equator

Updated 05/20/2014 | Published 05/17/2014

Products Featured in This Question

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(444)

$55.17

Replacement Wiring Harness for Tow Ready Nissan Vehicle Wiring Harness

(81)

$20.96

Curt Relay Kit for Nissan Armada or Titan Aftermarket Tow Package

(155)

$29.83

Question:

For the 2012 suzuki equator, I already have the 4 pin connector attached in the rear, but I dont recall installing a relay kit inside the truck. I havent had to use it yet, however in am picking up a new trailer during the week. I hooked a test led light up to the connector, I see the turn signals work but I have no idea about the brake lights. Is the relay kit a must, and if so do you sell just that portion seperetly? Thank you in advance for your time

asked by: Michael

Helpful Expert Reply:

If the 4-pole connector you speak of was factory installed, everything should already be functional. If you've just installed a 4-ploe, using a part like # 118263, then the relay kit # C57000 would be needed. The brown relay activates the 12-volt circuit to the trailer connector (which you won't need since you have a 4-pole) and the two blue relays activate the right and left turn signal and brake lamp.

Since you mentioned that you got a signal at the trailer connector with the turn signals, it sounds like the relays might already be in place. Go ahead and test for the brake lamp signal. Your tester should go hot on the pin fed by the yellow and the green wire when the brake pedal is pressed.

If you've installed the # 118263 without the relays, it would explain what you have going on. The turn signals would work, but the running lights would not.

If your truck wasn't equipped with the tow package, and you simply plug that connector in, your directionals and brake lights will work, but you will have NO running lights. In order for the running lights to be active, the relays need to be installed. To install them, you'll need the jumper harness included with the # C56225. The good news is that the # C56225 includes the relays, but it also includes the 4 pole connector you already have. At least you'll have a spare on hand if the connector ever gets damaged.

I've linked you to an install video showing the relays and the trailer wiring harness being installed.