Is There a 50MM Coupler For an EZ Loader Boat Trailer
Published 04/05/2024
Question:
My tow vehicle has a non-detachable 50mm ball. My trailer has a 2 coupler. Should I replace the coupler? The trailer is an EZ Loader with Fulton hitch. Recommendations appreciated.
asked by: Mike V
Expert Reply:
Since your tow vehicle has a non-detachable hitch ball you are going to have to look into a different coupler. The only couplers we have for a 50mm ball is a Multi-Fit like the Dexter # T2343400. This particular coupler does bolt to a 3" pole tongue and depending on your current bolt pattern may require drilling additional holes. It is rated for up to 5,000lbs so you would want to verify if this is enough for your EZ Loader trailer.
Product Page this Question was Asked From
Dexter Coupler - Painted - Multi-Fit Ball - 3" Channel - Bolt On - 5,000 lbs
- Straight Tongue Trailer Coupler
- Standard Coupler
- 1-7/8 Inch Ball Coupler
- 2 Inch Ball Coupler
- Bolt-On
- 5000 lbs GTW
- 3 Inch Channel
- Hand Wheel Latch
- 2-Bolt
- Standard Grade
- Dexter
more information >
Continue Researching
- Shop: Dexter Coupler - Painted - Multi-Fit Ball - 3" Channel - Bolt On - 5,000 lbs
- Q&A: Brake Replacement for Dexter 023-326-00 Brakes
- Q&A: How To Determine Replacement Hubs And Brakes For Boat Trailer
- Q&A: New Brake Assemblies, Hub/Drums, Brake Lines, and Bearing Buddy for Trailer with 3,500 lb Axle
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Best Replacement for a Shelby Hand Winch 5405
- Q&A: Spring Hanger and Axle Diameter Measurements for Installing Leaf Springs on Single Axle Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Looking for a 50mm Trailer Hitch Ball
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How Does a Trailer Hitch Coupler Work?
- Article: Trailer Couplers