Is There a 50MM Coupler For an EZ Loader Boat Trailer
Published 04/05/2024
Question:
My tow vehicle has a non-detachable 50mm ball. My trailer has a 2 coupler. Should I replace the coupler? The trailer is an EZ Loader with Fulton hitch. Recommendations appreciated.
asked by: Mike V
Expert Reply:
Since your tow vehicle has a non-detachable hitch ball you are going to have to look into a different coupler. The only couplers we have for a 50mm ball is a Multi-Fit like the Dexter # T2343400. This particular coupler does bolt to a 3" pole tongue and depending on your current bolt pattern may require drilling additional holes. It is rated for up to 5,000lbs so you would want to verify if this is enough for your EZ Loader trailer.
Product Page this Question was Asked From
Dexter Coupler - Painted - Multi-Fit Ball - 3" Channel - Bolt On - 5,000 lbs
- Straight Tongue Trailer Coupler
- Standard Coupler
- 1-7/8 Inch Ball Coupler
- 2 Inch Ball Coupler
- Bolt-On
- 5000 lbs GTW
- 3 Inch Channel
- Hand Wheel Latch
- 2-Bolt
- Standard Grade
- Dexter
more information >
Continue Researching
- Q&A: Parts Needed to Flat Tow a 2025 Ford F-150
- Q&A: Brake Replacement for Dexter 023-326-00 Brakes
- Q&A: Replacement Hub and Drum Assembly for Lippert 4.4K 136214 Hub and Drum
- Q&A: Recommended Replacement for a Titan WF48-S Fireplace
- Q&A: Meaning of MTI Number On Dexter Hub and Drum Assembly
- Q&A: New Brake Assemblies, Hub/Drums, Brake Lines, and Bearing Buddy for Trailer with 3,500 lb Axle
- Q&A: How To Determine Replacement Hubs And Brakes For Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)