How Tight Should Compression Fitting # D13032 Be when Installing a Transmission Cooler
Updated 08/08/2013 | Published 08/07/2013
Question:
Hi guys! With regards to the compression fitting installation, can you please tell me how tight I should tighten the crush nut and the barb fitting. Do I need to go all the way until no thread is left?
asked by: Sergei
Expert Reply:
Generally, you will tighten the fittings as much as you can with normal hand tools. If you then do a test after installation by starting the vehicle, check for leaks at the fittings. If you notice even a a drop of fluid leaking out then you will need to tighten them down further. Heat can make the metal expand so checking for leaks is important.
in the video I have linked you will see our installer using regular wrenches to tighten down the hardware. Notice that he is making the fittings tight but not over torquing anything, just making them tight.
Product Page this Question was Asked From
Derale Transmission Line Compression Fitting Kit - 3/8" Line to 3/8" NPT Barb
- Accessories and Parts
- Transmission Coolers
- Fittings
- 3/8 Inch NPT Hose Barb
- Derale
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Derale Transmission Line Compression Fitting Kit - 3/8" Line to 3/8" NPT Barb
- Q&A: How to Determine Which Line is the Return Line for Installing Supplemental Transmission Cooler
- Q&A: Recommendation For Dust Cap With Grease Nipple For Trailer
- Q&A: Transmission Cooler Recommendation for a 2002 Chevy 2500HD Silverado with 4L80E
- Q&A: Transmission Cooler Recommendation for a 2004 Chevy Silverado 2500HD with 6.0 Towing a 5th Wheel
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Frequently Asked Questions About Transmission Coolers
- Q&A: Replacement Lock and Keys for UWS Toolboxes
- Q&A: Do Transmission Coolers Have to Install Right Side Up Or Can they be Upside Down
- Q&A: Can a Transmission Cooler be Installed Vertically Instead of Horizontally