How to Safely Lift Landing Gear Legs on 2020 Cedar Creek 38FBD 5th Wheel to Swap Out Supports
Updated 05/08/2020 | Published 05/07/2020
Question:
I need to retract the front jacks one at a time about 4 inches to put concrete blocks under for support the support I have cracked how can I safely do this without hurting the rv thanks in advance 2020 cedar creek 38fbd 5th wheel
asked by: Lloyd S
Helpful Expert Reply:
The best way to swap out the supports under the landing gear legs from the Lippert Ground Control 3.0 # LC358590 on your 2020 Cedar Creek 38FBD 5th wheel is to hitch the RV to your tow vehicle and then retract the landing gear with the controller.
Aside from that I'm not sure what else would work unless you had an entire lift system that can handle the front end weight of your RV.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Will the MORryde Short Safe-T-Rail Telescoping RV Hand Rail Work on a 2014 Keystone Avalanche?
- Q&A: Best Auto Leveling System for 2014 Keystone Avalanche 5th Wheel Trailer
- Q&A: Can A 30 Amp Surge Protector Be Used On A 50 Amp Travel Trailer?
- Q&A: Replacement Jack Motor For The Lippert Ground Control 3.0 4 Point System
- Q&A: Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Replacement Lead Leg For The Lippert Ground Control 3.0 On A 2021 Grand Design 3030RLS
- Q&A: How To Determine Which Pin Box I Have and What Replacements Are Available