Can Welding On Stabilizer Jacks to RV Damage Electronics
Question:
I wanted to know if welding the jack legs on would create any issues with electric? I have a 2013 Shasta Oasis
asked by: Crystal
0
Expert Reply:
Arc welding can possibly damage electrical devices on the RV so if this is what you plan to do I'd recommend disconnecting the wiring from the batteries etc. A safer method would be welding with a torch. Welders typically say just to disconnect the battery and connect the ground as close to the weld as possible and you'll be fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Leveling Scissor Jack - 24" Lift - 5,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Scissor Jacks
- Steel
- 4001 - 5000 lbs
- Manual Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Scissor Jack Recommendation to Replaced Damaged Ones on R Pod Trailer
- Q&A: Replacement Awning Arms for Lippert Edge 58 inch Awning
- Q&A: Troubleshooting A Flashing Back Light On A Go Power Solar Charge Controller
- Q&A: Titan Replacement for Dico Trailer Idler Hub 17214
- Q&A: Replacement Toggle Switch For A Fastec FIC ETJ3500 Electric Jack
- Q&A: Correct Replacement Tire for Jingu 17.5 x 6.75 Tires
- Q&A: Recommended Replacment for a FIC 3500 Electric Jack
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Brake Controller Installation: Starting from Scratch
- Article: Beginner's Guide to RV Awnings: How to Open, Close, and Maintain Your Awning