Can Brass Valve be Used on Atwood Water Heater Plastic Drain Plug
Updated 08/12/2019 | Published 08/10/2019
Question:
Hello I have an Atwood water heater with plastic threads. It is in a 1997 truck camper. Will these threads work for that? Thanks
asked by: Joan W
1
Helpful Expert Reply:
Yes, as long as the threaded part on your Atwood water heater accepts a 1/2" fitting the Camco Water Heater Drain Valve Replacement # CAM11703 will work just fine even though it's brass.
expert reply by:
Jon G
1
Product Page this Question was Asked From
Camco Water Heater Drain Valve Replacement - 1/2"
- Accessories and Parts
- RV Water Heater
- Valves
- 1/2 Inch
- Drain Valve
- Camco
more information >
Continue Researching
- Q&A: Water Heater Valve Replacement and Galvanic Corrosion Possibility
- Shop: Camco Water Heater Drain Valve Replacement - 1/2"
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Thumb Latch Cylinder Measurements
- Q&A: How to Choose Correct GlowStep System for Varying Ground Height Situations
- Q&A: Replacement Stop Cock Valve Recommendation for 1/4 inch Fitting
- Q&A: Is There an Upgrade Kit for a MaxxAir Roof Vent Fan To Use Wireless Remote
- Q&A: How To Get To the Holes To Install the Lippert Components Universal Slide Out Wear Pad
- Q&A: How Many Wear Pads Are Normally Used in Lippert Slide Out