Instructions for Replacing a 2.5 x 2.5 Heavy Duty RV Slide-Out Gear Pack

Question:

how to replace the gear block on slide out. I have been under and see the block just need to know if the 2 long bolts that go thru the block will let it drop where I can replace if necessary.

asked by: Edward J

Helpful Expert Reply:

I will be happy to explain the replacement instructions for Lippert Components 2.5 x 2.5 Heavy Duty RV Slide-Out Gear Pack # LC123356.

The exact instructions are as follows:

In the event a gear pack needs to be replaced, follow these steps:
1. Run slide-out room half way out.
2. Place a jack under the inner arm of the slide-out.
3. Jack room up just enough to remove pressure off the gear pack.
4. Remove drive bolt from the cross shaft.
5. Remove bolts which hold the gear pack assembly in place on the outer rail.
6. Drop out the damaged gear pack.
7. Install the new gear pack.
8. Install bolts to hold gear pack assembly in place on the outer rail.
9. Install cross shaft and bolt.
10. Gear pack assembly does not need to be torqued down, only adequately and securely tightened.