How to Update Software on an Edge Programmer
Updated 05/13/2015 | Published 05/12/2015
Question:
I tried to install my edge ep59yr and it came up with need update how do I do that ??
asked by: Larry F
0
Expert Reply:
To obtain your update simply go to edgeproducts.com and on the left side of the page you will see Fusion Software Update, click on that prompt. You will then register your unit. After your unit is registered, you can plug your unit into your computer and download the specific updates needed for your vehicle. You can also update over Wi-Fi.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Edge Gas Evolution CTS3 Performance Tuner - Color Screen
- Performance Chip
- Performance Tuners
- With Monitor
- Color Touch Screen
- No - Not California Approved
- Evolution
- Edge
more information >
Continue Researching
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Hitch
- Q&A: Trailer Hitch Fit Recommendation for 1988 Toyota 4Runner
- Q&A: Does the Edge Evolution Programmer Allow a 2010 Chevy Suburban to Return to Stock After Tuning
- Shop: Edge Gas Evolution CTS3 Performance Tuner - Color Screen
- Q&A: How to Connect a 100 lb. Propane Tank to a 5th Wheel RV
- Q&A: Parts Needed to Connect Two 40 lb Propane Tanks to Stove Top
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: JR Products Automatic Changeover 2-Stage Propane Regulator
- Shop: MB Sturgis Sturgi-Stay T-Fitting w Hose - Type 1 Valve - Quick Disconnect, Disposable Cylinder Ports
- Shop: BioLite 2-in-1 CampStove 2+ - Smokeless - 1 Burner
- Shop: RV Antenna and Radio
- Shop: RV Exterior Lighting
- Shop: RV Mattress
- Shop: RV Plug Adapters
- Q&A: How to Update Your Edge Gas Evolution CTS2 Tuner
- Q&A: 2-Wire to 3-Wire Converter for RV with Combined Lighting and Trailer with Separate Lighting
- Q&A: Recommended Rear Suspension Enhancement And Weight Distribution Hitch For 2010 Ford Ranger