Will Curt Front Mount Hitch Part # 33328 Reduce the Ground Clearance of my 2007 Honda Ridgeline  

Installation of the front mount receiver #33328 is not all that difficult on a 2010 Honda Ridgeline. There is a little bit of fascia trimming required and a couple of the bolts have to be fishwired in but other than that it bolts into place. The…

For a front mount hitch the part #33328 that you referenced has been confirmed as a fit for your 2014 Honda Ridgeline so it would work well for you. The winch mount part #C31010 would then work well as a winch mount for the front hitch. I attached a…

After reading the instructions it does sound like the fascia is removed and trimmed for the CURT 2 Inch Front Hitch, part #33328 to fit on your 2007 Honda Ridgeline. Then, the hitch and fascia is reinstalled together, so if you have to remove the…

For the purposes of structural rigidity or safety, there's no problem whatsoever with leaving that bit of fascia off if you wish. The fascia plays a role in how the wind is directed under the vehicle as you're driving down the road, but I…

If you use a hitch extender like the Brophy Hitch Extender, part #HE06 on your front trailer hitch it will extend the length by 7 inches, but it will reduce the hitches overall weight capacity by 50 per cent. That means the tongue weight capacity on…

The correct front mount trailer hitch we offer for a 2013 Honda Ridgeline is the Curt Front Mount Trailer Hitch Receiver part #33328 which offers bolt-on installation. This will then allow you to attach a variety of accessories such as snow plow,…

To install the Curt front mount hitch #33328 on a 2012 Honda Ridgeline, trimming of front air dam or fascia may be required. The instructions that I have linked for you shows what needs to be trimmed. I have also included a picture that shows what…

I do have a solution for you but there are no front mount trailer hitches available for the 2003 Honda Element. What I recommend is a Trailer Valet XL trailer dolly such as #TVXL2 which has a 2 inch ball or #TVXL25 which has a 2-5/16 inch ball. These…

For your 2005 Honda Pilot we have the Curt hitch part #33328 as a confirmed fit. I attached a link to install instructions for this hitch for you to check out as well. I also uploaded a picture I took from the install instructions that shows the…

In order to install your old Curt Front Mount Trailer Hitch Receiver part #33328 on a 2006 Honda Pilot you will want to use the Replacement Hardware Kit for Trailer Hitches part #RHK. Once you arrive at the product page you will need to enter…

Curt Front Mount Trailer Hitch Receiver #33328 for your 2012 Honda Ridgeline weighs approximately 23 pounds. I have included a link to the installation details for you.

I believe you by winch mount you are asking about a front hitch on your 2014 Honda Ridgeline, and you do need to (temporarily) remove the plastic fascia/spoiler to install the hitch that fits, which is the Curt Front Mount Trailer Hitch Receiver…