Custom Fit 2014 Ram 3500 Accessories

The factory prep package on a 2018 Ram 3500 is pretty apparent so odds are you don't have this if you are unsure. If the indentations for the four outer pucks and center gooseneck hitch ball are present but there are no actual holes in the…

The B and W hitch for your 2014 Dodge Ram 3500 actually does not use rails like most of the B and W hitches. Because of that there is nothing from your old hitch that would transfer over. So you would need the #BWGNRK1314 which comes with…

Since your 2014 Dodge Ram 3500 with an 8 foot bed does not have the factory underbed hitch prep package you will want the B and W Gooseneck Hitch part #BWGNRK1314. This hitch has a gross towing weight of 30,000 lbs and vertical load limit of 7,500…

Yes the 4" Offset Ball for B&W Turnoverball Gooseneck Trailer Hitches part #BWGNXA4085 is an exact fit for the B&W Turnoverball Underbed Gooseneck Trailer Hitch part #BWGNRK1314. It will also give you that extra inch…

The B and W Turnoverball Gooseneck Hitch part #BWGNRK1314 that you referenced fits the dually and single rear wheel models of your 2018 Ram 3500.

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the…

If you already have brake drums you will not have to replace them unless they are damaged or became overheated and have discoloration on the inside armature surface where the magnet rides, grooves in the armature surface, or severe wear where the…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The one really big downside to gooseneck towing is that there isn't a great solution for short bed truck clearance unlike fifth wheel towing. With fifth wheel hitches you can use a slider hitch and have the clearance issue handled. With gooseneck…

There are a couple of ways to adjust the position of tailgate #VGM-07-4000 for a better fit. First, the latches on either side of the tailgate have a minimal adjustment range of 1/32 inches. This is to fit around the striker bolt that goes into the…

The Angled Hold-Downs for Truck Bed Campers #HSAB should work very well for your 2003 Chevy Silverado 2500. We had a customer leave us a review that said they were very easy to install and reinstall and that it only took a few minutes, so I think…

I spoke with Thule regarding the glue alternatives for installing the Thule Elite Van XT, part #TH302013, on a 2018 Ram ProMaster 2500. In order to mount this without glue, you will need to use bolts to keep this mounted on your ProMaster. That would…