2025 Jeep Wrangler Unlimited Replacement Top

Hey Carole, thanks for reaching out! The Swagman Swivel Hitch Extender #S86SR has arms that are about 29-1/2" long. Swagman actually has a dimensional photo that gives more dimensions that you'll ever want that I'm attaching for you to…

Good question, Chuck! You will not need the Brake Relay #RM-88400 when installing the Roadmaster 4 Diode Wiring Harness #RM-15267 on your 2018 Jeep Wrangler JL Unlimited. This is because the stop light switch circuit on your Jeep JL will go dead…

Hello Andrew, Well that sounds like quite the fun trip, what state or states will you be traveling through? You're asking a really important question, especially since you're planning a cross-country trip with about 250 pounds of bikes and…

Hey Neal, we have confirmed with Curt in the past that the front hitch part #C73ZV is confirmed to fit your 2022 Ram 2500 Power Wagon. What are you planning on putting in the front hitch?

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

Hello Christopher, We do not have the bow system for your 1993 Isuzu Amigo, and that is part of the roof frame. That is required, as well as the factory hardware for a replacement soft top, so if you have that you can use the Pavement Ends Replay…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I have another option for you, but the Timbren Heavy-Duty Axle-Less Trailer Suspension - Straight Spindle - Regular Tires - 3,500 lbs #TASR35HDS04 you were looking at actually uses 5200lb hub and drum assemblies and is not available with the 5 on…

Although the #TASR35HDS04 Timbren Axle-Less suspension you'd looked at has a 3500 lb capacity but is compatible with hubs that would have a 5200-7000 lb capacity, depending on which bearing set is used. We don't offer an idler hub compatible…

The front bumper on your 2005 Jeep Wrangler does resemble the Smittybilt XRC. If that is what you have then you actually won't need a base plate kit as you can use D-Ring adapters to flat tow your Wrangler. We have verified this with Smittybilt…

For your 2017 Jeep Wrangler Unlimited system to flat tow it behind your Itasca Ellipse, I recommend the following: For your base plates, I recommend the Blue Ox Base Plate Kit #BX1126 which will give the front of your Jeep a clean look. It has an…

It sounds like you've created your own umbilical to go from the 7-way on your RV to a 7-way on your Jeep. The Hopkins connector #H20043 is 4 feet long, which isn't going to be long enough to bridge the gap of space for flat towing. You're…