Result:

I have a 2005 Snow bear utility trailer 4x6. Looking to replace the wheel bearings. Not sure where to start the tag says 1,980 lbs? I have a VIN # if that helps. | Based on what you've stated you most likely have a 2000lb axle with a straight...

I installed the Curt trailer wiring module a few years ago on my daughters 2018 Jeep Compass. It was working properly after install. She hadnt pulled a trailer for awhile, but when getting ready for a trip, we found that the right side lighting...

I have a small trailer hauling ass ? a 4x5 .I would like to put buddy bearings protectors the outside bearing is a # L44548 I think maybe 1.98 id ??? HELP what number buddy bearing do I need to order from you? Thanks | If you are sure that the...

Hey: I have a little 4x4 cargo trailer. Looking to upgrade to bearing buddies instead of the old grease cap set up. The current grease cap measures 2 inches from the inside lip. What size bearing buddy do I need? Thanks | We have a few Bearing...

We have a 1960s Air streak trailer, It has Hadco 5R series 6 x 5.5 drum/hub assembly all one piece, 12inch x 2inch electric brakes, 5200lb axle. I guess they dont make them anymore, What would you recommend? | Since we don't have the info...

I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...

I have a troubleshooting question. We purchased a used 2019 Jeep Compass with a Curt trailer light kit. The fuse was blown. When I replaced the fused the right side taillight came on with no lights turned on. My question is itbit possible the...

Got the harness installed and all the lights on the vehicle work, no problem, but I getting nothing on the trailer lighting. Could it be a bad ground connection? | It very well could be a bad ground connection between trailer wiring harness...

I have a 2013 jeep compass. I checked trailer lights with 12 volts and they work fine. I am blowing the 10 amp fuse at the battery when I plug in my 4 pin tester and tail and signal lights go hay wire then fuse blows. Is it possible for the...

White green brown yellow need to know how to match red brown blue black | The Hopkins 4-way connector, part # HM48205, uses white for ground, brown for the running lights, green for right side (passenger) turn signals and brake lights, and yellow...

I bought the 119250KIT as recommended from your site. I've hooked it up every way possible that is listed. There is an answer to a question just like mine. If my headlights are on I get the brake lights on all the time on the trailer and the...

I replaced my old controller with the Tekonsha p 3 controller and I have a 2001 GMC Sierra 2500 hd. I have only tried it on my empty 18 foot car hauler but no matter what adjustments I make I cannot get the brakes to lock up to adjust them!...

All trailer lights work except running lights. Trailer works fine on other vehicles. Brakes, turn signals work fine Thank You | First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester like # PTW2993...