1998  x   >   !SportRack  x   >   !AirBedz  x   >   Van  x   >  

Hi, Have a Ford E250, 1998 that I just purchased and want at least a Class IV Hitch. What I dont want to do is having to move/modify the exhaust. Drilling holes in the frame if needed is not a problem however it would appear that there are...

Will this replace exciting front sway bar on a 1998 E450 SD 7.3 Diesel Motor home chassis. | Anti-sway bar # RM-1139-115 does replace the factory sway bar on the 1998 Ford E-450 Class C motor homes. |

will replace the factory steering stabilizer on my 1998 Ford E-450 SD Class C 7.3 Diesel motorhome. | Steering stabilizer # RM-RBK24-RSSC does not replace the OEM damper on the 1998 Ford E-450 Class C motor homes. |

What is the distance from center of hitch pin hole to closest edge of carrier when carrier is NOT folded up? | The distance from the center of the hitch pin hole to the nearest portion of the Curt Cargo Carrier # C18100 when folded down is 8...

Looking to upfit my 1998 Ford E350 15 passenger van with a 4 pin factory wiring setup to a 7 pin setup with a proportional brake controller. What are the right products I need? Concerned that the 15 passenger van might need longer wires to...

Hello,I recently purchased and reviewed the Packem 3 trimmer rack for an open trailer and LOVE it. I am looking for a Backpack rack to add to the unit and noticed the PK-OP1 accessory. I was wondering if the backpack blower part of the accessory...

what type would you recommend for a standard bumper. | For a 1998 Dodge B1500 van with a standard factory bumper (and no weld nuts in the frame) the hitch I recommend is the USA-made Curt # 13015. I suggest this hitch because it has a higher...

Hi, I have a predicament. I have a dual motorcycle rack to put on my class 4 tow hitch, but I need to extend it out at least 8inch in order for the motorcycle handle bars to fit. Is there any extender that would have a 600lb tongue weight? |...

Want to verify air bag kit #F2061 is the correct kit for my 1998 Ford E-350 RV Chassis with duallys , Thank you for any help , | Yes, the Firestone Ride-Rite Air Helper Springs # F2061 is the correct kit for your 1998 Ford E-350 Chassis with...

Hi, Im looking to put an 84 basket on the roof of my 1998 Ford E-150. Do you sell the baskets with the hardware for attaching to the rain gutters, or do I have to buy a pair of crossbars first? Can you show me some products that will do the...

Can I install this on my 1998 pleasureway rv that is based on dodge 3500 ram van? I assume the rbk20 would be the mounting kit? If youre not sure, could I order it and if the mounting bracket doesnt fit, and I havent installed it, then return...

I bought a Tekonsha Voyager from you, I now want to use it in a 98 Ford Van. Which adapter do I buy? 3035 P or 3045 | If your 1998 Ford Van has a factory 4 or 7-Way trailer connector then you would use wiring harness # 3035-P. If you do have...

Ford Coachmen Camper Van-Would this work on my 98 ? Is it a do it yourself project? rear of vehicle weighs a little over 1200 lbs, more than the front as is. | The Firestone kit # F2061 fits 2007 to 2008 Ford E-250 cab and chassis vans and 1992...

Where can I find wiring harness for my 1998 Ford E350 Club Wagon to be connected to Hayes 81725 Syncronizer Brake Control? My van has factory tow wiring under dash. Thank you. | We offer the Ford-specific Hayes brake controller wiring harness...

i am looking for a hitch for a 1998 tioga. what do you offer?need 15000 lbs | The only option to put a trailer hitch receiver on your 1998 Tioga Class C Motorhome is going to be the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver #...

Do you have the dimensions of the bedtred floor liner for the 1998 Econoline E-150? I cant tell if it literally covers the entire floor from the back cargo area to the front up under the dash or stops just behind the driver seat or what it...

Need a hitch to fit my 1998 E350 Four Winds motor home assuming it is same as E350 van but not sure. Does it double capacity of hitch when using weight distribution set up? Also need brake controller and 4 pin to 7 pin update can you shoot...

Mid way thorough my 1998 ford e-350 15 passenger install after picking up the parts here https://www.etrailer.com/question-701673.html. I found the OEM connector under the dash to connect my Curt Custom Wiring Adapter # C51322 , but cannot...

Hi, I have a Ford E-350 based Class C RV and right now I have my spare 16inch dually wheel/tire mounted on the front, which I accomplished using a Draw-Tite front hitch and Draw Tite 6715 Hitch Mounted Spare Tire Carrier plus a J pin stabilizer...

Draw-tite model 65001 front hitch, will it fit my 1998 Ford 450 with Winnebago coach? | The Draw Tite Front Mount Hitch part # 65001 that you referenced has been confirmed to fit your 1998 Winnebago coach that is built on a E-450 cutaway chassis...

Hi, I have a 1999 Pleasure Way van built on a dodge chassis. The van has a back tire, door that swings out and a 2 inch hitch. I need a rack that will be relatively easy to load a 65 pound bike with 4 inch fat tires. I’m in pretty good shape...

Do you know the height of this ball from base flange to top of ball? They appear a bit taller than other balls. Im trying to figure the best ball mount/hitch ball setup to get the height I need for my trailer. Thanks. | I went and pulled a 2"...

Will this fit a 98 Ford E-350 Van? Thanks for your help! | The Pilot Adjustable Ladder Rack, # CG-903, is designed to fit vans with rain gutters. This rack clamps securely to the gutters with no drilling required and allows you to carry up to...

First off, I REALLY like the little videos you all provide. That’s a big deal for me. I’m looking at the T style hook and keeper. My question is, assuming I attached the hook to the RV wall in the keeper to the door, what happens when you drive?...