!V70  x   >   !Victory  x   >   Highland Ridge  x   >  

Do you sell just the drum? Part BD2-545-17 | Hey Rob, The BD2-545-17 has been phased out, so you would need to buy the entire hub with new bearings # AKHD-545-35-EZ-K. The reason for this is you should not be using used bearings in new races...

The clip on my F521NSBS snapped off is there a replacement cap for this as there are screws and looks like you would not have to replace the whole plug? | The Furrion 50 Amp RV Power Inlet part # F52INSBS offers a very straight forward complete...

Does the screen need to be removed when pulling a UTV in and out? | The two panels of the Classic Accessories Toy Hauler Screen for Fiberglass or Aluminum Toy Hauler # 052963799842 have a zipper that you can unzip to pull your UTV in or out...

Will this pin box fit my 2021 Highland Ridge Roamer 354 MBH 5th wheel without adaptors? I have a BandW Companion Slider 5th wheel hitch. | The 2021 Highland Ridge Roamer 354 MBH comes with the Lippert 1621 or 1621HD pin box. Item # 325-GH-8040...

I have a 2015 open range roamer 345RLS. The auto leveling control pad needs replacing. What part do i need? Here is the current part | Thank you for providing those pictures. The correct control panel is the Replacement Control Panel for Lippert...

I have a Furrion Model DV1200 stereo in my Open Range Trailer. It quit working after a converter was replaced, i.e. turns on then off then on etc. Tried reset, nothing. What would replace this unit? | The Jensen RV Stereo - Double DIN -...

I recently had my awning ripped off while driving through Kansas during a severe storm. Prior to that, I had purchased replacement arms to replace some damage that had happened from an unrelated instance, so I have brand new arms with the power...

Can this replace a Axle Tek BD2-865 drum which is original equipment on our 2016 Highland Ridge 3X Open Range Fifth wheel? Axle is a Lippert 24400 - 7000 lb with a spindle that uses a 2.25 inch ID grease seal. I also see that your assembly...

How much play is there supposed to be in the hitch and receiver, I checked hitch and it measures 1 7/8sinch my receiver inside dimension is 2. Just seems like its quite a bit of play, especially when pulling my camper and controlling the sway...

I have a Atwood Water HEater Model number: GC6AA-10E and its starting to leak. I would like to replace with tankless.. What would you recommend. Measurements of existing inside to inside is: 16W x 12 1/4 high | Excellent idea to go with a...

I have a 2020 Mesa Ridge fifth wheel that has the 50 amp service with the threaded collar on the current Furrion power cord. I need to get an extension cord, as my factory cord will not reach the power pole at the campsite. I would like to...

I am missing one from the 5th wheel we just bought. The center cap measures 4.25 in height and the diameter is about that size also. My question is when I look the 2015 Highland Ridge into the filter it says I should be getting the 3.19. I went...

Hello, Id like to strengthen the suspension of my rig. Weve traveled a lot with it and it will likely continue to see regular use. Im interested in adding crossmembers and either replacing the current suspension or upgrading it with stability...

We are looking to purchase a bike carry for our 2018 open range ultra lite travel trailer that attaches to a hitch we will have installed,2 inch square. E bikes are in our future in the next couple of years. What would you guys suggest. | Since...

I have a mesa ridge 2019. Vin 58tbh0bn3k3mm3072. Weight is 5800lbs..tandem axle 5 lug. Electric Brakes. My axle is bent so I am going to replace both. What axel do I need. Is it worth upgrading to a heavier duty one. | Hey Eric, you could upgrade...

The running lights on our trailer are not working. All the other lights are working properly. What should we explore as possible causes? Thank you. | The most likely causes to the issue you have are dirty trailer wiring connector pins which...

How do I turn the LED light on the jack off? | The light for the Bulldog Powered Drive Trailer Jack # BD500187 can be turned off by flipping the on/off switch on the left of the face to the off position. |

Looking for a rear hitch on the rear of my fifth wheel I was thinking of a car dolly with a 2 inch ball to pull my 16 ft enclosed trailer behind my open range 3x is their a hitch available to make that happen | I have a solution for you, but...

Will this hub fit this axle. See pic. | Hello George. I can confirm that yes, the Dexter Trailer Hub and Drum Assembly # 42866UC3-EZ will indeed fit your Lippert 7K axle. I was able to get ahold of Lippert and they confirmed the following specs...

I have a 2017 highland ridge roamer 367bhs and I’m looking for a lift kit for it. I have. 2020 gmc 3500 and my rv is nowhere close to level. And I have about 6-8” of height between the rails and rv so I can’t lower my hitch. I am not sure what...

I have a 4x4 2500 dodge ram with a 2inch lift. Im thinking that the 3inch adjustment on the shank may not be enough. Do you have a shank with more adjustment, maybe up to 5 or 6 inches? I need to purchase a 14,000 distribution hitch. The...

Im looking for wheel bearings and seals for a 2020 Highland Ridge Mesa Ridge 26bhs. Do you have these? | The Hub Bearing Kit # BK2-100 contains the bearings, races, grease seal, cotter pin and tang washer for one hub on your 2020 Highland Ridge...

My 2021 5th wheel sits low in the rear. Can you recommend a 2 or 3 inch lift kit | Thank you for the photos! I have a few options for your 2021 Highland Ridge Mesa Ridge 284RLS and it really just depends on what you're looking to get out of...

I am looking to convert my Highland Ridge Utra Lite trailer. It currently has two Interstate Group 24 batteries. I know the charger also has to be changed. Can you provide me with what I would need for a complete change over. Thank you....