Can Prodigy P2 Brake Controller Be Used on Tandem Axle Trailer
Will this work with a 3 axle trailer? In the description is says for 2 axles | The Prodigy P2 part # 90885 is actually good for up to 4 axles so it would easily handle your triple axle trailer. |
Best Way to Carry Two Electric Bikes on a 2000 Chinook Motorhome
I put a picture of the rear of my 2000 Chinook Concourse 21 ft RV. There is a hitch in rear and I wonder if this rack will work with the rear door. I have 2 E bikes. I am also debating putting a hitch in the front and mounting the rack there....
Will T5 LED Light Bulb DI43VR Replace Fluorescent Bulb
I want to replace the existing fluorescent. Currently I have a Philips F8T5 installed. Pin to pin length is 11 7/8. Distance between pins is 1/4. Will this work for me? Also, I have read that some led replacement bulbs can fry the ballast....
Are Curt Weight Distribution Spring Bars Compatible with an EAZ-Lift V-5 Weight Distribution Head
I purchased a 6,500lb travel trailer that came with an Eaz-lift V-5 weight distribution hitch, but no bars. These Curt spring bars look like they would clip in. Would these bars work for the V-5 system? | Although the bars may look like they...
How Much Height Does Fan-Tastic Roof Vent # FV802250 Add to Trailer
Part #FV802250 Ceiling fan. I have this unit in my RV. The thermostat quit working. This appears to be an exact match, with the exception that it appears to not be flush mounted like mine. Can you tell me how tall it is from the mounting plate...
Recommended RV Air Conditioner System For A 1998 Chinook Concourse Class B Motorhome
I have a 1998 Chinook Concourse and am looking at replacing a Dometic Duo-Therm Penguin. It is attached to a Dometic Dual Zone thermostat. I need to make sure that everything that I buy will directly replace my existing unit with nothing else...
Do Light Strips DI44ZR Just Wire In, And Width & Height of Strip
2 quick questions: 1-Do I need to remove the existing ballast, or do I just connect them up as per the instructions? 2-What is the W and H measurement? I have an older T5 fixture and want to make sure there is adequate room. Thank you | I...
2005 Forest River Rockwood Rhino Pop Winch Replacement Recommendation
Hello! We would like to replace our motorized winch, photo attached, with a Pop Up Tent Camper Lift System Winch that is hand cranked. We are not sure which winch will fit our camper. Can you help make a recommendation? Thank you in advance...
Recommended RV Roof Vent Cover For 2001 Chinook Glacier
I have a 2004 Chinook glacier and I need two vent cover just the out side covers do you have them | We sure do! For your 2001 Chinook Glacier I recommend the MaxxAir Standard RV and Trailer Roof Vent Cover # MA00-933069 which will install over...
How Does a Curt Trailer Hitch Install on a 2012 Dodge Ram 4500 Cab and Chassis
When lookin at the image of the hitch it shows holes on the top but yet there are no holes on the bottom of the frame on my 2012 ram 4500 chasis cab....also the installation guide is not loading....I was wondering if u could confirm how the...
Recommended Replacement Vent For A 2007 Forest River Rockwood Ultra Light Travel Trailer
I have a 2007 Rockwoid Ultra light camper. 8296 SS is the model. I want to replace the vents on the roof. Do you know what size? Do you sell the vents? I prefer tinted. Or can I change the cracked top and the screen instead of replacing the...
Can Front Hitch Installed On Motorhome Carry a Cargo Carrier
I have a 2004 e350 motor-home I installed your front receiver hitch What if any concerns are there putting a cargo rack on the front instead of the rear of the unit? | You'd most likely just need to be aware of the carrier on the front of the...
Cargo Carrier Compatible With 1-1/4 Inch Class I Trailer Hitch on Camper
I have a 2002 Rockwood Freedom popup camper that already has a hitch on it, but when I tried to mount my existing hitch cargo carrier old one similar to etrailer, but not yours - I bought it before I found you it did not work. Apparently the...
Installing The Diamond RV Lighting T5 Bulb Into A Ballast With A Switch
Im not the handiest guy when it comes to electricity so I need some guidance. The directions with the light are very confusing. I have a switch on the fixture. Your video review says to just wire the new LED into the power source, but in...
Filter Your Search
Contact and Help