Do Light Strips DI44ZR Just Wire In, And Width & Height of Strip
2 quick questions: 1-Do I need to remove the existing ballast, or do I just connect them up as per the instructions? 2-What is the W and H measurement? I have an older T5 fixture and want to make sure there is adequate room. Thank you | I...
Installing The Diamond RV Lighting T5 Bulb Into A Ballast With A Switch
Im not the handiest guy when it comes to electricity so I need some guidance. The directions with the light are very confusing. I have a switch on the fixture. Your video review says to just wire the new LED into the power source, but in...
Can Front Hitch Installed On Motorhome Carry a Cargo Carrier
I have a 2004 e350 motor-home I installed your front receiver hitch What if any concerns are there putting a cargo rack on the front instead of the rear of the unit? | You'd most likely just need to be aware of the carrier on the front of the...
Recommended RV Air Conditioner System For A 1998 Chinook Concourse Class B Motorhome
I have a 1998 Chinook Concourse and am looking at replacing a Dometic Duo-Therm Penguin. It is attached to a Dometic Dual Zone thermostat. I need to make sure that everything that I buy will directly replace my existing unit with nothing else...
Recommended RV Roof Vent Cover For 2001 Chinook Glacier
I have a 2004 Chinook glacier and I need two vent cover just the out side covers do you have them | We sure do! For your 2001 Chinook Glacier I recommend the MaxxAir Standard RV and Trailer Roof Vent Cover # MA00-933069 which will install over...
Best Way to Carry Two Electric Bikes on a 2000 Chinook Motorhome
I put a picture of the rear of my 2000 Chinook Concourse 21 ft RV. There is a hitch in rear and I wonder if this rack will work with the rear door. I have 2 E bikes. I am also debating putting a hitch in the front and mounting the rack there....
Will T5 LED Light Bulb DI43VR Replace Fluorescent Bulb
I want to replace the existing fluorescent. Currently I have a Philips F8T5 installed. Pin to pin length is 11 7/8. Distance between pins is 1/4. Will this work for me? Also, I have read that some led replacement bulbs can fry the ballast....
Filter Your Search
Contact and Help