Does Trailer Wiring for 2007 Mitsubishi Raider Sense Varying Voltage for Brake Light Activation
I have a few questions about the 118323 combined lights and brakes 4 way connector harness for my 2007 Mitsubishi Raider. 1. Is the brake lights intensity changed based on the amount of power going to the brakes? 2. Description indicates that...
Replacement Wiper Blades for a 2000 Fleetwood Bounder
I need the type that are held in place with two small set screws. The screws attach the blades to the arm. | According to ClearPlus the correct replacement left and right wipers for your 2000 Fleetwood Bounder is # CP77261. Based on your description...
Can Weather Tech Bug Shield Survive Going Through Car Wash
Will I be able to go through the car wash after its in place. | Yes, the Weather Tech Easy-On Stone and Bug Shield Deflector # WT50150 that you referenced is sturdy enough and mounts sturdy enough to survive going through a carwash. |
Replacement Wiper Blades for a 2005 Fleetwood Bounder37U
Hi, Im looking for 25.5inch wiper blades for my 2005 Fleetwood Bounder 37U. Theyre the screw on style with 2 small screws on each blade. | The correct wiper blades for your 2005 Fleetwood Bounder 37U is the ClearPlus Heavy Duty Windshield Wiper...
Recommended Transmission Cooler For 2006 Mitsubishi Raider
Installation of external transmission cooler on a 2006 mitsubishi raider with factory tow. What extra fittings might I need for install and what kit would be best | For your 2006 Mitsubishi Raider, the Derale Series 9000 Plate-Fin Transmission...
Replacement Module Recommendation for Kwikee Steps on 1992 Fleetwood Bounder RV
need a control module, for electric steps on a 1992 fleetwood bounder diesel pusher. stairs open, but will not retract. motor and gear box work great, when door is opened, but will not close when door is shut. suspect that module is bad, or...
Wiring a 4-Way connector on a 2006 Mitsubishi Raider
I dont know collor code to my truck Mitsubishi Raider 2006 | The taillight wiring colors for your truck could be any color, manufacturers change wiring colors for many different reasons and often within the same model year. To determine the...
Would Charging Vehicle Battery While being Flat Towed Cause RV Battery to Drain Toad Battery
I have set up my HHR for towing and would like to run a line from my RV to charge this. My RV is wired through the seven pin plug with a wire to do this. It is only on when the ignition is on. My concern is will the RV draw from the battery...
Is Wiring Adapter Available to Connect 4-Flat and 4-Round to 7-Way Vehicle End Connector
Good Afternoon, Looking at your wiring adapters I dont see exactly what I need... My RV has a seven blade, I have a tow dolly with 4 flat and additional lights which have 4 round. Are their any adapters which would accommodate my needs? or...
Parts Needed to Install a Trailer Brake Controller on a 2006 Mitsubishi Raider
How to in stall a Prodigy P2 brake controller on a 2006 Mitsubishi Raider with Factory Tow Kit..Cant find a quick connect. Can I use one made for Dodge Dakota? I do have a v8 if that makes a differance.. | I spoke with my contact at Tekonsha...
Electric Brakes On Trailer Working Intermediately With 2006 Mitsubishi Raider
I have an issue with my trailer brakes working only when they want to. Ive tested the controller as stated, checked red and black for power, severed the blue wire, its working properly. As I drive trailer brakes will start to work sometimes...
Can 2008 Mitsubishi Raider 2WD be Flat Towed with Driveshaft Disconnect
I have a 2008 Raider 2WD with a drive shaft disconnect. I currently tow it on a dolly. I would prefer to tow it 4 down but cant find base plates. Any suggestions? Thanks | If you have a rear driveshaft disconnect on your 2008 Mitsubishi...
Anti-Sway Bar and Steering Stabilizer Recommendations-1997 Fleetwood Bounder on Ford F-53 Chassis
LOOKING TO ADD YOUR SWAY BAR FOR A BETTER RIDE ALSO SINCE IT IS A 97 THINKING OF NEW POLY BUSHINGS IN THE FRT AND A NEW STEERING ABSORBER ??? SHOCKS ARE GOOD. | The Roadmaster # RM-1139-143 is a fit for your Fleetwood Bounder on a Ford F53 chassis,...
Will the Bedliner Need to Be Removed for PAL3600 Installation for 2006 Mitsubishi Raider
I have a bedliner installed in my 20006 Mitsubishi Raider, and it covers then inside of the tailgate. Will I have to remove the bedliner to install the tailgate lock? | You will need to be able to access the three bolts on the inside of the...
Tool Box Recommendation for a 2006 Mitsubishi Raider That Fits Below the Rails
I need a tool box for the bed if my truck but I want it to fit comfortably inside I dont want it showing | I have found several toolboxes that will fit your 2006 Mitsubishi Raider, however, the DeeZee Toolbox # DZ8748HDS is not one of them that...
Trailer Wiring Harness Recommendation for a 2007 Mitsubishi Raider
I need to add a 7 wire harness to my 2007 Mitsubishi Raider pick up so I can pull a small camper. The truck does not have a factory wireing harness for towing. Which harness would be the best for me to use. | For a 4-way wiring harness recommendation...
Install Instructions for GloLight LED Trailer Tail Light
Hello! Can you provide install instructions? | To install the GloLight LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 32 Diodes - Round - Red Lens # STL190RB you just need to match the wires by color or function. On the light: white...
Filter Your Search
Contact and Help