Slide-Out Awning for Slide-Out that is 79-3/8 Inches Wide
I think I know the answer to this question but too expensive to make a mistake. My measurement is 79-3/8” outside of flange to outside of flange. The 7’ topper says box size up to 79” and the 7-1/2’ topper box size starts at 80”. I suspect...
How to Determine the Correct Replacement Landing Gear for a 2008 Forest River Wildwood 5th Wheel
I have a 2008 forest river wildwood sport 5th wheel toy hauler camper. I need to repair the landing gear. The off-side, the side away from the jack mechanism for raising and lowering the stands, drive shaft broke where the extension connects...
Where Can An Excel RV Tankless Water Heater Be Installed In A 2007 Fleetwood Nitrous Hyperlite TT
Why not a bedroom or bathroom? We have a Fleetwood Nitrous toy hauler. There are no rooms other than a bed room or bathroom. Tankless designs like these wont fit where the Atwood was. We were thinking about installing this under the bathroom...
Does Atwood Air Command Kit # AT15028-22 Come with AT15022
What parts of AT15022 are NOT included the purchase of AT15028-22? I am replacing an existing Carrier V AC. | All of the Atwood Vent Kit part # AT15022 that you mentioned is included with the Atwood Air Command Rooftop RV Air Conditioner w/...
Is there a Hole to Route Trailer Wiring Harness on a 1990 Ford LTD Crown Victoria
My car has the tow package says theres a 32 mm hole by rear 1/4 panel for wires to go through,i dont see it. Have you ever worked on one of these is it possible they didnt put the hole and plug in the vehicle? | We haven't had a 1990 Ford Crown...
Can the Epicord Battery Disconnect Switch # 277-000096 be Installed on Negative Battery Terminal
I have always been told to disconnect the negative side first when attempting any repairs or modifications concerning DC electrical. With this in mind, would this switch work just as well interrupting the negative terminal vs. the positive...
Trailer Spindle Got a Nick In it from a Grinder Should the Axle be Replaced
I was grinding the bolts off my trailer I slipped and put a nick in the spindle is it ok or do I need to replace it or the axle? | How deep is it? It is hard to tell from the picture. You may be able to use some emery cloth and take care of...
Trunk Bike Rack Recommendation for a 1990 Ford Crown Victoria
I have an older car I tease my sister tell her my bike is worth more than my car it is a 1990 ford crown Vic need a trunk rack for female bike will this work? | The Thule Passage bike rack part # TH910XT that you referenced has been confirmed...
Replacement Crank Handle for Ram 5th Wheel Landing Gear Compatibility With 2007 Fleetwood Nitrous TT
I recently purchased a 2007 fleet wood nitrous hyper lite toy hauler and I was wandering if this would work on my se up? It looks identical to the one I used that belonged to a friend who owns an 05 weekend warrior. | I don't have any way of...
Exhaust Modifications for 2001 Ford Crown Victoria with Dual Exhaust
This hitch for the crown vic says dual exhaust needs to be modified. What are the modifications that will need to be preformed as I have a p71 police interceptor that I would like to put a class 3 with 2 reciever on. | In order to clear the...
Recommended Replacement Bearings and Grease Seal for a 2007 Fleetwood Nitrous Hyperlite
Im having trouble trying to get a couple extra sets of wheel bearing and dust seals for my toy hauler. My outer bearing is marked 15123 and the inner bearing doesn’t have anything that I can see. Is it possible to find out what I need with out...
2 inch Hitch that Fits 1989 Ford LTD Crown Victoria
I have a 1989 LTD Crown Victoria I would like to pit a Draw Tight Hich 2inch what model would you guys recommend Thanks | For your 1989 Ford LTD Crown Victoria we have the Draw Tite Hitch # 41116 as a confirmed fit for a Class III 2 inch hitch. |
Filter Your Search
Contact and Help