7-Way and 4-Way Trailer Connection and Step Bumper for 1995 Ford F-350
I just purchased a 1995 F-350 dully that Im putting a new 16K Curt receiver hitch on. Due to the 10inch bumper the previous owner put on the truck, Im also having to replace the bumper to just a regular step bumper. I will be pulling a lot...
Solar Panel Kit Ability to Run Air Conditioner 24/7
Are these made run air conditioning 24/7 | The Go Power Solar All-Electric Kit will not be enough to power the air conditioner unit 24/7. The Advent Air RV Air Conditioner w/ Ceiling Vent and Start Capacitor - White # ACM135C will have a running...
Instructions for Hopkins Trailer Wiring Harness # HM42525
I lost the instructions to install it. Is there a way i could get new ones? | I attached a picture that has the install instructions you requested for the Hopkins trailer wiring harness # HM42525 that you referenced. |
Mounting Bracket Kit for SnowBear Personal Snowplow on 1995 Dodge Ram
Do the #sb379-003 94-02 ram pickup mounts fit a snowbear personal plow. These seem to be right and I believe they will fit. This is my plow. | I checked with my contact at Snowbear (and sent him the picture that you attached of your Personal...
How To Add a 7-Way and Brake Controller On a Motorhome
I have a 95 ford f53 chassis 35ft motorhome. I need to add a brake controller and 7pin connector. The motorhome has a 4 pin connector already. What kit do I need that will provide.. 45 feet of cable? Also, I need a replacement holster...
Replacement Kwikee Step Module 909513 for 1995 Allegro Bay Motorhome
Need a replacement brain for electric steps Kwikee 909513 | We've checked with Lippert before and the correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part # LC379606...
Replacement Soft Top and Doors For 1995 Jeep Wrangler
Current flip top is part #44583 flip top with upper half doors by pavement ends.web site says this product is no longer made. My question will the flip top part #pe4458715 fit and is this hardware same as #44583 soft top and upper doors are...
Sway Bar Recommendation for 24 Foot 1996 Fleetwood Jamboree
do you have a sway bar for a 24 ft fleetwood jamboree 1996 Ford e-350? | Yes, for your Fleetwood Jamboree built on a Ford E-350 chassis we have the Roadmaster steering stabilizer part # RM-1139-117 as a confirmed fit for the rear bar and then...
Recommendation for a Bike Rack to Fit a 1995 Lincoln Town Car
I just need to verify that you actually have a model that will fit a 1995 Lincoln Town Car. It is a RWD Sedan with a HUGE deck lid. My old ALLEN brand did not have long enough straps to reach the upper edge of the deck lid trunk. Thank you for...
4-Way and Fifth Wheel 7-Way Recommendation for 1995 Ford F-250
I have a 95 f350 dually. I need a harness for my 5th wheel. It has a junk 4 way into original harness connectors, it also has trailer brake in cab, Im assuming its run in original harness since I cant find any wires running down frame. Do you...
Does Bed Need to Lift Up to Install Draw Tite Gooseneck part # 8339-4440
I have a 95 Chevy 2500 diesel 4WD Cheyenne single cab with 8foot bed . I plan to install this myself. Truck used to have a gooseneck hitch installed which was removed to accommodate a bed camper. There are already holes drilled in the bed. Looks...
Distance Between Mounting Holes of B and W Hitch BWHDRH25124
I need the dimensions of the mounting holes for the BWHDRH25124 hitch. My concern is, I have a 1995 K1500 GMC with a flat bed, The frame appears to measure 37inch outside to outside. Is this hitch wide enough, I need the width between mounting...
Where to Locate Blue Wire to Connect for Brake Controller Function on a 1995 Ford F-150
Where is the blue wire for brake controller at the rear of a 95 F150 which will connect to the 7 Pine connector. I cant locate it. Vehicle has dash plug connector for controller with blue wire but cant locate blue at rear of truck. Thanks |...
Will the Stallion Ramps 288-07503 Work With a 3600 Pound Vehicle That Has 10 Inch Rear Tires
I have a portable shed having a metal sill plate with a garage door with the floor of the shed being approximately 8inch off the ground. Your 3000 lb ramps would be ideal given the low 8inch rise to the shed floor and the fact these ramps have...
Can You Remove a Leaf On the 2-Leaf 1K Slipper Spring with Radius End
Can I remove the second leaf? What is the weight capacity if I do? My trailer will be around 400 lbs. all up, I think the 1000 lb spring will be too much for it. | The 2-Leaf Slipper Spring w/ Radius End part # SP-177275 cannot be disassembled....
How Does the Airaid EconoAid Custom Throttle Body Booster Install
How difficult is it to install this spacer? Looks like I can unbolt the four mounting bolts holding the throttle body on and slip the spacer and gasket in between the manifold and carburater and bolt it back. But if I have to disconnect linkage...
Trailer Wiring Recommendation for a 1995 Toyota Tacoma
Hi I need to install a light kit so I can pull trailers with my truck...do you carry a harness to help me? Thanks! | We do carry a trailer wiring kit confirmed to fit your 1995 Toyota Tacoma. For that you would want the Draw Tite Wiring Kit...
Distance from Bolt Hole Center to Center Left to Right on Curt Front Hitch # 31198
What is the bolt-to-bolt width on each pair of bolts and between the 2 pairs of bolts on the Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2 Item # 31198? Thanks! | The measurements of the Curt hitch # 31198 are 38-7/8 inches from...
Frame Bracket Dimensions for B&W Turnoverball Underbed Gooseneck Trailer Hitch BWGNRK1000
What are the length and width of the rails that run down the frame of the vehicle? | The frame brackets that come with the B&W Turnoverball Underbed Gooseneck Trailer Hitch part # BWGNRK1000 measure 28" long x 2-3/4" according to B&W. |
Pros and Cons of Running Two Inflation Valves or One in Air Bag Suspension Kit on Vehicle
What are the pros and cons of using 1 Schroeder valve in a air bag install | The biggest pro to using one valve stem to maintain air pressure in an air bag kit is that you always know that both bags will have an equal amount of pressure in them....
Bestop Soft Top Recommendation for a 1995 Jeep Wrangler YJ with Hard Top and Full Steel Doors
I have a 95 Jeep Wrangler with a factory hardtop and full steel doors. Looking to install a soft top. Does this kit contain all the hardware necessary to covert to a soft top? | I have exactly what you would want. I spoke with my contact at...
Installing DX2 Brake Controller On Fleetwood 1995 Bbounder Ford 450
I took the plugin off the break switch and read out the hot side. When I tied in to the non power side and reinstall the plug in on the switch I get the same voltage across the switch as the hot side unplugged. The break lights do not come...
Parts Needed to Install 7-Way and Brake Controller in 1995 Chevy C1500
i have a 95 c1500. im looking for a wire kit to buy. current have 4 flat connection. looking for a kit to wire in so i can use my traliers brake system. and boats brake system too | You would need to convert the 4-way to a 7-way so that you...
Bearings and Seal for a 3,500 lb Dexter Torflex Axle
I have a #10, Dexter, Torflex axle, rated at 3,500 lbs., and I need spare bearings/seals. According to the Operators Maintenance Manual, these are the parts I have/need: Inner Bearing/Cup = 68149/68111 Outer Bearing/Cup = 44643/44610 Seal =...
Filter Your Search
Contact and Help