Replacement Taillight Lens Recommendation for 1986 Fleetwood Southwind
have a taillight cover missing on 1986 fleetwood southwind, but one that comes up in search looks nothing like it horizontal array of three covers 2 red one clear - missing one red - outer driver side do you have such a part? thx | We probabaly...
Will Lippert Slide-Out Controller Work To Bypass Factory Slide-Out Wiring
Hello, I have a well cared for Fleetwood Southwind Class A RV Coach with slideout wiring problems. I want to bypass the original wiring in the coach where the problems exist behind the walls and major components and install a controller...
Roof Rack Landing Pads Recommendation for a 2011 Mazda 2
Looking for Yakima or Thule landing pads for Mazda 2. They are a single bolt direct mounting point. | The Yakima landing pads that are recommended for your 2011 Mazda 2 would be the LandingPad 11 for Yakima Control Towers # Y00233. If you want...
Mounting Hole Pattern of Flow Max RV Fresh Water Pump
Will this replacement pump bolt up to existing mount | I attached a picture that shows the mounting hole dimensions of the Flow Max RV Fresh Water Pump part # LC689052 that you referenced to compare to what you have now. This mounting pattern...
Recommended Sway Control For A 2008 Fleetwood Southwind Motorhome On F53 Chassis
Hi I have a 2008 Fleetwood Southwind 32vs on a ford F53. Im trying to figure out what would be the best option to get it to handle better in wind and passing trucks. Its all stock other than a read trac bar we installed. Ive looked at sway...
What Would Cause Trailer Tires Size ST205/75-14 to Wear Out on Insides
My Toy Hauler has 2 3500 lb axels totaling 7000 lbs carry capacity. On the RV sticker it states the the gross weight is 7700 lbs fully loaded of which Im not over. So are my axels able to carry 700 lbs over what they are rated for? Im having...
Replacement Spring Kit for Power Gear Jack on 2003 Fleetwood Southwind 37U
I think this is the right one for my motorhome, but want to make sure before I order anything. My rig is a 2003 Fleetwood Southwind 37U on the Workhorse chassis. | There unfortunately is not a database that tells us which specific parts like...
Manual Step Replacement Recommendation for Kwikee 32 Step On RV
1994 Fleetwood Southwind with 32 series kwikee electric steps. I want to replace with manual pull out steps. My current steps are 24inch wide with 8inch rise/ and with a 18inch high threshold, will the SMFP-2100 be a viable replacement step?...
Tow Bar Wiring Recommendation for a 2013 Mazda 2
I am going to tow a 2013 Mazda 2. It has a 3wire system, one for turn signals, one for tail lights and one for brakes. How do I do this? | For lighting you can use the diode kit, # RM-15267, and not have to worry about cutting into the taillight...
Recommended Platform for Boat Trailer Tongue
I am looking for a boat trailer tongue walk board. | We have a few options for you to consider in a platform for your boat trailer tongue. We don't carry a specific walk board, but we do have some similar items like the following: HitchMate...
Determining Which Drop/Rise Ball Mount will be Needed to Transport my Coleman Popup Camper
Hello I was wondering was /rise ball mount should I purchase for 2011 Mazda 2 to tow Coleman popup camper? I havent picked up camper yet to measure. Thank you in advance, | I can help you figure out what which ball mount you will need for...
The Yakima Fit My Car feature www.yakima.com returns no results for my 2012 Mazda 2. Their website may not be functioning properly? Are you absolutely sure the Yakima Control Tower Roof Rack will work on a Mazda 2? Thanks! | Yes, I confirmed...
Will the Swagman XC 2-Bike Rack Part # S64650 Fit a 2012 Mazda 2
Hello, I have 2012 mazda2 with CURT 11073 Class 1 Trailer Hitch. I was wondering if I could fit Swagman XC Cross-Country 2-Bike Hitch Mount Rack on it. Thanks. | Yes, the Swagman XC 2-Bike Rack part # S64650 will work with the Curt Trailer...
Can the RV Refrigerator Roof Vent Cap and Base Be Installed from the Outside?
Does this have to be installed from inside or can it be mounted to roof from outside? | The RV Refrigerator Roof Vent Cap and Base item # DMC37FR needs to be mounted to the roof from the outside. |
How To Lower Exhaust When Installing Curt Class I 1-1/4 Inch Hitch # C11073 on 2011 Mazda 2
Is it difficult to lower the exhaust to install a hitch on a Mazda 2? | To lower the exhaust on a vehicle when installing a hitch is not difficult if done correctly. The main thing is to lube the rubber hangars with WD-40 and that will allow...
Recommended Rear Anti-Sway Bar For 2005 Fleetwood Southwind 32V Built On Ford F-53 Chassis
What is the correct roadmaster rear anti sway bar for a 2005 fleetwood southwind 32V on a ford chassis? Thanks | Since your 2005 Fleetwood Southwind 32V is built on the Ford F-53 Chassis and is under 34' long you will need the Roadmaster Rear...
Need a Vehicle 7-pin Round Adapter to Connect to a Boat Trailer 5-Pin Flat
Bought a pontoon boat with a 5 pin flat wiring connector. My van has a 7 pin round trailer receptacle. Can you recommend an adapter? | We do offer several adapters for a 5 pin flat to a 7-way blade vehicle connection. If your van connection...
Do the Camco RV Refrigerator Vent Cover Base CAM42161 and Top CAM42160 Fit Each Other?
Does the camco 42161 and 42160 refrig base and cover fit each other | Yes, they do! The Camco RV Refrigerator Vent Cover - Base item # CAM42161 and the Camco RV Refrigerator Vent Cover - Top item # CAM42160 do indeed fit each. |
What Size Are The Pins In The Roadmaster Adapter Kit For Blue Ox Motorhome Mounted Tow Bars
Hello, What size are the pins in the Blue Ox to Roadmaster tow bar adapters. Thank you, Gene | Here are the dimensions for the Roadmaster Adapter Kit for Blue Ox Motorhome Mounted Tow Bars, part # RO64FR. pin size = 3/4" pin length = 5" measurement...
Towed Vehicle Tail Lights Aren't Working with RV Connected Using 6-Way Connector
I installed a new 6 pin plug on my tow vehicle. Both turn lights and brake lights on the car are working fine, but I get no tail lights when the RV lights are on. I wired it the same as it was. Any suggestions? | In order to help troubleshoot...
Recommended SumoSprings for a 2017 Fleetwood Southwind 36L
Which Sumo springs fit my 2017 Fleetwood Southwind 36L? is there a Timbrem option as well? | Hey Randy, I spoke with SumoSprings and they mentioned that you can use the SumoSprings Maxim Custom Helper Springs # SSR-187-54-1 for the rear and...
Cabinet Opening Size Required to Install Greystone Built-In 0.9-Cu-Ft Microwave Oven 324-000106
We have a 2005 Fleetwood Southwind Motor home. The opening is 19 1/2inch deep by 21 1/2inch wide by 15 1/2inch high. Will the 324-000106 greystone be compatable for that opening? We are replacing a Samsung microwave/convection oven. | Greystone...
Could Curt Hitch for 2012 Mazda 2 Tow a Motorcycle Trailer with Kawasaki Ninja 250R
I have a Kawasaki Ninja 250r its about 400lbs, will this hitch be able to pull it? My vehicle is a 2012 Mazda 2 Hatchback | ThCurt trailer hitch part C11073 has a towing capacity of 1,500 lbs total trailer weight and 150 lbs tongue weight. If...
Replacement Bushing Kit for 2004 Fleetwood Southwind Front Anti-Sway Bar
i have a 2004 fleetwood rv diesel motor home do you sell just the front sway bar bushing links? i dont need the whole bar , just the links with the bushing i live in neb | We do have bushings for your 2004 Fleetwood Southwind front anti-sway...
Filter Your Search
Contact and Help