Loading Ramp Recommendation for 2,100 lb Lift
I am needing a ramp for my small trailer that will be carrying a small vertical mast scissor lift. The lift weighs about 2100lbs. The trailer deck is only about 14" off the ground. Do you have a ramp that I can use to make this work for my needs?...
Recommended Loading Ramps for a Motorcycle with a Sidecar
I am needing a ramp/ramps to load and unload a motorcycle with a side car into and out of a semi trailer approximately 4 foot in the air. What style would be recommended? | With how wide you set up is with the side car, I suggest going with...
How Far Down Do the Stallion Stabilizer Jacks Sit When Closed on the Trailer
How far does the closed Jack hang below the frame of the trailer? | From where the Stallion Stabilizer Jacks # 288-01892-2 mount to the trailer to the bottom of the mounting bracket measures 3-3/8" but to the lowest point on the leg is 4-3/8"...
Can I Use the Roadmaster Tire Carrier with a Stowaway Cargo Box Attached to RV
I have a 2019 Sprinter 2500 RWD with a hitch tongue capacity of 500 pounds. My RV is a 2020 Pleasureway Ascent. I want to add a spare tire carrier to the van and saw the RM-195125 as a possible solution. I also use the Stowaway Swinging out...
Where is this Stallion ramp manufactured? | The Stallion # 288-07432-2 folding cargo ramps are manufactured in China. If you'd prefer a US made alternative, I'd recommend the Gen-Y # 325-GH-R84 84 inch long aluminum loading ramps. If you...
Recommended Stabilizer Jacks for Off Road Use
My Husband and I are converting a cargo trailer into a camper, and are looking for some advice. We may be going off-road, and are concerned that attached stabilizers may get ripped off. What would your suggestion be? Thanks!! | This is...
Solution to Mount Aluminum Car Hauler Ramps in Enclosed Trailer for Transport
Do you have any kind of mounting equipment that can attach the ramps to the trailer for transport? | We do have a solution to mount the # 288-07503 in what I'm assuming is an enclosed trailer. What you can use is the CargoSmart Rotating Safety...
Recommended Drop Down Trailer Stabilizer Jacks for An Aluminum Frame Trailer
DO you sell down stabilizer jacks that are aluminum for aluminum trailers? | I do have some great drop down trailer stabilizer jack options but I am not aware of any made from aluminum. Instead, I recommend the Stallion Stabilizer Jacks part...
How many Boards Will The Ramp Kit For 2x8 Boards Complete One or Two
the board ramp kits are they for one board or two | You get all the hardware needed to complete two 2 inch x 8 inch boards to make a pair of ramps in the ramp kit, part # 288-07400. |
Can Air Be Released From Timbren Axle-Less System to Lower Ground Clearance
I would like to know if there is the possibility to empty the air in the suspension of the trailer, to have less clearance with the ground for unloading my bike? | The Timbren Axle-Less Trailer Suspension Systems, like the 3,500 Pound # A35RD545...
Which Aluminum Loading Ramps for Loading Harley Davidson TriGlide onto Trailer
I am thinking of using 288-07452-2 pair and 288-07452 single for loading my Triglide trike on an open trailer. I would ride it on and off. Total wt would be 1500 - 1600 #. I would probably make a metal spacer to keep the tracks a the need widths...
What Basket will Fit the MaxxTow Ladder Rack # MT70423 on My 2008 Toyota Tundra?
Hi Was wondering if they make bars that attach to these cross bars running front to back so I can attach a roof top basket to it. Also do you have covers that are large enough to go around these cross bars? This is for a 2008 Toyota Tundra without...
Warranty for the Tire Grip Vehicle Traction Recovery Tracks
What is the warranty on your traction mats? | The Tire Grip Vehicle Traction Recovery Tracks # 288-07411-2 you referenced come with a 1-year limited warranty. I have attached a review video for you to check out. |
Will a Fairing Fit the Aluminum Roof Mounted Cargo Basket # 288-09200
I recently purchased this aluminum roof rack and was wondering if there are any recommendations for a good wind fairing that fits this rack? also, what is the difference between a $20 fairing and a $100 fairing? Thank you! | To answer your...
Can I Use the CargoSmart S-Curve Loading Ramp Set for a 1800 Pound SxS?
These will take 1500lbs on both. Can I use them to load an 1800lb SxS if only 1 axle is on the ramps at a time? I need it to go up about 18inch onto a trailer that doesnt have ramps. Im thinking that since not all the 1800lbs is on the ramps...
Recommended Ramps For Loading 1690lb UTV In The Bed Of A Truck
Have a UTV sxs that weighs 1650 lbs dry 1690 lbs curb. Need ramps to load to bed of truck. suggestions? | We have ramps that will work perfectly for loading your 1690lb UTV into the bed of your truck. I recommend the Arched Loading Ramp Set...
Do You Have a Tailgate Ramp Combo for a Trailer?
I have a 4 ft wide utility trailer. Im looking for a combination loading ramp tailgate that I can install on this trailer. Do you have or make this item | No, I am sorry we do not. The only ramps we have available are ones like Item # 288-07503...
Will Stabilizer Jack Leg Fit in MaxxTow Adjustable-Height Ball Mount
What are the dimensions of the square leg? I wanted to use the leg foot from the Square Leg Stabilizer Jack with 18 inch Travel in place of the adjustable ball mount on the MaxxTow Adjustable-Height Ball Mount - 2inch Hitch for trailer stabilization....
What Loading Ramp Do You Recommend For My 1993 Chevrolet Camaro
Hello do you think the ramps will be good to load with a small vehicle like a Camaro Chevy Camaro | I recommend the Aluminum Car Hauler Ramp Set - 60" x 14-1/2" - 6,000 lbs - Qty 2, part # 288-07502, instead. It is rated up to 6,000 lbs. The...
Could MaxxTow Hydraulic Pickup Truck Crane # MT70238 Be Used to Lift Generator into Rear of SUV
Would your hydraulic hitch crane be acceptable to move a heavy generator into the back of a suburban? I noticed in the pictures they all show it being loaded into a flat bed truck | Yes, the MaxxTow Hydraulic Pickup Truck Crane # MT70238 can...
Can Stallion Stabilizer Jacks Be Used to Lift Trailer to Change Tire
On a small enclosed cargo trailer weighing 640lbs can I install 4 stabilizing jacks on each corner and then if needed use them to raise the trailer to change the tire. | Mounting four of the Stallion Stabilizer Jacks # 288-01892-2 on each corner...
Could Bump In Road Cause Drop Leg to Fall on Stallion Stabilizer Jacks
how secure are the jacks when they are in the up position not being used when you are towing the trailer. Looks like a good bump could cause them to fall down during towing. | The drop leg on the Stallion Stabilizer Jacks # 288-01892-2 that...
Will the Tire Grip Vehicle Traction Recovery Track Help with Loose Gravel on Inclines
Do they help with loose gravel on an incline at a boat ramp? | Yes the Tire Grip Vehicle Traction Recovery Track part # 288-07411 would be a very viable option for gaining extra traction on the slippery gravel boat ramps. Here in the Midwest...
Rung Spacing and Sharpness of 88-9/16 Inch Long Arched Loading Ramp Set
I’m wanting to know if I can use the 288-07452-2 ramps to load a mobility scooter into my truck bed. I wasn’t sure if the wheels would hang up between the rungs. Also the scooter has hard rubber wheels and are the holds on the rungs sharpe and...
Filter Your Search
Contact and Help