Result: diode kit

have diodes innew part to keep light from flashing and just operate with brakes | i need a third brake light for center of rear window for safety. want for 1975 dodge dart. should have diodes innew part to keep light from flashing...

wiring. Then I recommend using the Vehicle to Vehicle Tail Light Converter # 118158 to splice into your | I have a 2010 Silverado 2500 HD towing a 30 ft. travel trailer. Trailer has four round...

the outer diode on each side of the lights illuminates, and not very brightly. Nothing changes when I press | I installed a Tekonsha 118670 kit with ROLA 59516 LED Light kit and Am having issues. Only the outer diode on each...

and the ground wire connection to the mounting hardware. The other possible issue is that some vehicles | I removed all old lights and wiring. I used a new led light kit. I grounded the white wire to bare...

resistors like the Load-Resistor Kit # DI34ZR. It really has to do with the vehicle's wiring as much | I ordered a left and right assembly, do I need any load resistors to prevent hyper flashing...

wires to correct this issue instead of fitting a new harness. Its there a way to fix this issue | I recently asked this question: Converter on my Nissan Xterra. I have all led lights on my Xterra. The converter...

Yes, the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # C56173 | I Have a 2015 Honda accord sport model. Does it fit my car? | Yes, the Curt T-Connector Vehicle Wiring Harness...

removed the bed to add a custom flatbed . I have Led lights with a ground, signal wire and stop/tail. I | I recently purchased the hoppy 5 wire to four flat converter. I have a 86 toyota pickup which i removed...

Hello, I just installed a Curt 56320 custom wiring harness on my 2019 Ford Escape. I have running | Hello, I just installed a Curt 56320 custom wiring harness on my 2019 Ford Escape. I have running lights,...

trailer w/ brakes, 7 pin connector, and LED lights. Curt Trailer Hitch Receiver - Custom Fit - Class | Can you confirm the following parts list to set up a 2013 Volvo xc90 to tow a dual axle cargo trailer...

see this causing wiring issues and you may consider taking the vehicle to a mechanic. Most aftermarket | I just had Uhaul install a hitch on my 2019 Ford Edge Titanium. My left blinker is now blinking really...

will fit. If you want another option, I recommend the Diamond Vehicle LED light bulb # DI52VR | I have the blue ox non-led bulb and socket kit installed. Are these replacement led bulbs compatible replacements...

the light come out of the chrome housing? Again this is for a custom application and I will not need | I am in the process of rebuilding a car and will be installing LED tail, marker and front blinker lights. I’ve noticed from...

resistor kit like # DI34ZR. These can be needed if the wiring system is "looking" for the typically much | I have a customer with a 2006 Chevy Silverado 3500 with a utility box on the back. It has Peterson...

. They would both fit in the Optronics Rubber Grommet for 6-1/2 Inch Oval Trailer Tail Lights, part # A70GB | I have oval trailer lights that use a grommet to hold them in. The number on them is ST1P2. They look like your ST70RB....

not require load resistors. All of the LED elements that fit in place of an 1156 bulb are shown on the linked | Will the LED bulbs replace 1156 bulbs used for Travel Trailer Rear Brake, Turn signal and license plate light and...