GMC  x   >   Ram  x   >   !Dodge  x   >   Diamond  x   >  

Can the usb outlets and 12v cigarette lighter be wired in parallel, or do they need their own 12v power source on a separate fuse? | You can definitely wire the ports of the Diamond 12V Charging Station # DG61023VP in parallel. However, you...

Hi, I am looking at the DG52681light strips. The place I want to put them is about 25 ft. in length. Can I cut 2 strips and plug one into the other daisy chain to get the length or will I need to run separate power to each strip? Thank you,...

My truck does not have a 12V access in the rear of the bed. I have a Viair compressor that I would like to use to add air to lift shocks and/or truck/RV tires. Can I use my 7-pin or 4-pin connectors at the back of the truck for this? If so,...

921 led bulb My Ram 2016 2500 I Would like to convert the incadesent backup bulb to an LED, would i have to put a resistor in line or not. | When replacing the 921 bulbs on your 2016 Ram with LEDs like # DG52609WVP , you will only need to install...

Do you have to put load resistors on all LEDS installed or just the turn signal LEDS. I want to change my tail lights, back up lights, third brake light and license plate light all to LEDS. I have a 2016 Ram 1500 Big Horn addition. I read where...

To Whom it may concern, Is the mounting spring a wire loop or flat metal spring. If I have too replace the flat metal spring fixture one, how is it done without damaging the thin ceiling board in our 2016 Redwood 5th wheel? As I have already...

ANSI/RVIA states that a cigarette lighter receptacles need to be installed in a non-combustable outlet box unless it is thermally protected. Does the manufacture of this product state that it is thermally protected? | The Charging Station #...