!Designer Camper  x   >   !Windjammer Travel Trailer  x   >   Chinook  x   >  

I want to replace the existing fluorescent. Currently I have a Philips F8T5 installed. Pin to pin length is 11 7/8. Distance between pins is 1/4. Will this work for me? Also, I have read that some led replacement bulbs can fry the ballast....

Part #FV802250 Ceiling fan. I have this unit in my RV. The thermostat quit working. This appears to be an exact match, with the exception that it appears to not be flush mounted like mine. Can you tell me how tall it is from the mounting plate...

I put a picture of the rear of my 2000 Chinook Concourse 21 ft RV. There is a hitch in rear and I wonder if this rack will work with the rear door. I have 2 E bikes. I am also debating putting a hitch in the front and mounting the rack there....

1 I need to know where to measure from and to | The RV Ladder # LA-401 is 99-1/2 inches tall. This is from the highest point to the lowest point. See the image I've linked. So you'll need to measure on your 1999 Chinook Concourse to find...

I have a 1998 Chinook Concourse and am looking at replacing a Dometic Duo-Therm Penguin. It is attached to a Dometic Dual Zone thermostat. I need to make sure that everything that I buy will directly replace my existing unit with nothing else...

I have a 2004 e350 motor-home I installed your front receiver hitch What if any concerns are there putting a cargo rack on the front instead of the rear of the unit? | You'd most likely just need to be aware of the carrier on the front of the...

2 quick questions: 1-Do I need to remove the existing ballast, or do I just connect them up as per the instructions? 2-What is the W and H measurement? I have an older T5 fixture and want to make sure there is adequate room. Thank you | I...

I have a 2004 Chinook glacier and I need two vent cover just the out side covers do you have them | We sure do! For your 2001 Chinook Glacier I recommend the MaxxAir Standard RV and Trailer Roof Vent Cover # MA00-933069 which will install over...

Im not the handiest guy when it comes to electricity so I need some guidance. The directions with the light are very confusing. I have a switch on the fixture. Your video review says to just wire the new LED into the power source, but in...