What Are The Dimensions Of The Mounting Holes For the Draw-Tite Trailer Hitch Receiver # 75121?
Updated 05/17/2024 | Published 05/15/2024
Question:
What is the distance between the center of the bolt holes?
asked by: Maggie B
0
Expert Reply:
The bolt holes on the Draw-Tite Max-Frame Trailer Hitch Receiver # 75121 are spread 41" on center from the drivers side to passenger side frame. The 2 closest holes are spread 1-5/8" on center with the single hole being 8-5/8" from the nearest mounting hole as seen in the image I created below.
expert reply by:
Bud M
0
Draw-Tite Max-Frame Trailer Hitch Receiver # 75121 Mounting Holes Dimensions
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Is 2 Inch Hitch Ball Okay to Use With 2-5/16 Inch Coupler
- Q&A: Warranty Implications of Installing Trailer Hitch on 2019 Jeep Compass
- Article: Determining Trailer Tongue Weight
- Q&A: Installing Trailer Hitch on 1995 GMC Conversion Van with Aftermarket Bumper
- Q&A: Replacement Leaf Spring for Dexter 248744
- Q&A: What Size Generator Is Needed to Power a 15,000 BTU Air Conditioner
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement Trailer Hub for the TDE 46205 with Galvanized Finish
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Accurately Measure Trailer Leaf Springs