Need Instructions to Connect Factory Plug on 2004 Ford F-250 for Tekonsha Voyager Brake Controller
Published 11/11/2014
Products Featured in This Question
Question:
Im connecting tekonsha voyager break box to a 2004 f250 i have a plug factory just dont know which wires to hook to what off the controller Im attaching a pic of the plug i have if you can tell me which wires to hook to which from the plug to the controller box
asked by: Ryan L
Expert Reply:
To connect the factory plug to the brake controller you will need to wire as follows:
Controller Wire Factory Plug
Black to Red
Red to Lt Green
White to White
Blue to Blue
The plug on the end of the Tekonsha Voyager Brake Controller, # 39510, will need to be cut off before making any connections.
Another option would be to use the Tekonsha Plug-In Wiring Adapter, # 3035-P, in place of the factory plug. By using this adapter, no splicing would be required. Simply plug in one side of the adapter to the plug up under the dash and the other to the brake controller.
Continue Researching
- Q&A: Parts Needed To Add Electric Drum Brakes To A Trailer
- Q&A: Can Electric Over Hydraulic Brake Actuator Be Fully Submerged
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Differences Between Marine and Standard Hydrastar Actuators
- Q&A: Will the HydraStar Electric Over Hydraulic Actuator Part # HS381-8067 Work for Me
- Q&A: Adding Electric Over Hydraulic Disc Brakes to Boat Trailer
- Q&A: Converting Surge Brakes to Electric Over Hydraulic on a Tandem Axle Boat Trailer