How to Pick Out a Ball Mount for a 2007 Mitsubishi Outlander
Updated 10/27/2014 | Published 10/26/2014
Question:
Installed my trailer receiver and electrical connections without an issue. What are people using for a ball mount length and rise on the Outlander? Rear hatch lowers on the 2007 and the receiver is generally on the low side. Thanks,
asked by: Peter P
Helpful Expert Reply:
In order to pick out the correct rise/drop ball mount you want to pick one that will allow your trailer to be towed as level as possible. Since trailer heights can vary quite a bit there isn't a certain ball mount that I can guarantee would work for you. You will need to check out the FAQ article I attached to the right to see exactly how to pick out the correct ball mount.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Parts Needed To Install A Brake Controller In A 2012 Toyota Sienna LE
- Q&A: Thule Apex XT4 VS Yakima Ridgeback 4 On A 2017 Toyota Highlander
- Q&A: Roof Rack and Kayak Carrier for 2018 Mitsubishi Outlander Sport
- Q&A: Recommended 7-Way Connector for a 2024 Subaru Forester w/ a 4-Way Connector
- Q&A: How to Add 5-Way Trailer Connector on 2016 Jeep Wrangler
- Q&A: How To Install 5-Way Trailer Connector On 2015 Jeep Wrangler Unlimited
- Article: Determining Trailer Tongue Weight
- Q&A: Similar Tire Size Replacement for 7.50x16 That Is Radial Construction
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)