How To Fix Muffler Rattling Against the Trailer Hitch on a 2004 Honda CRV
Published 08/29/2008
Question:
I recently purchased a class III tow hitch and a bike rack from you for a 2004 Honda CRV. Unfortunately, the muffler keeps tapping against one of the mounting bolts, causing a rattle. Is there a particular solution you would recommend over others?
asked by: Kamil
Expert Reply:
When we have this issue on vehicles here at our shop. Sometimes we bend out the last exhaust hanger just enough to force it away from the hitch . Also the rubber hangers could be on the loose side causing too much play, you could try replacing with new rubber hangers. Check through your directions to see if it mentions flipping or removing an exhaust hanger.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Hitch Recommendation for 2006 Honda CR-V and Yakima Flipside 4 Bike Rack
- Q&A: Maximum Towing Capacity of a 2005 Honda CR-V
- Article: Trailer Hitch Installation Tips
- Q&A: What is the Difference Between the Curt & Draw-Tite Trailer Hitches For a 2006 Honda CR-V
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Q&A: Brake Controller Installation on 2007 Chevy Tahoe
- Q&A: Recommended 15 Inch Replacement for 205/75-14 Tire on Travel Trailer
- Q&A: Air Lift WirelessAIR Replacement Manifold Compatibility With A WirelessONE Compressor System
- Q&A: How To Tell The Difference From Right and Left Electric Brake Assemblies
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Can You Flat Tow a Honda CR-V?
- Article: Trailer Wiring Diagrams
- Article: Carrying on a Legacy: One Family’s Story of Grief, Growth, and a Global Pandemic
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch