What are Dimensions of Double RV Waste Valves Valterra T68C
Published 08/18/2026
Question:
What are all of the dimensions. It will be a tight fit but all you show are the termination measurements. Even the companys site does not show them. I saw somewhere an old drawing with some measurements from you folks but can not find it again, and it was for the older style of the T68.
asked by: Mike
Expert Reply:
Hey Mike, this is a great question but the dimensions of the valve part # T68C that you referenced are exact same as the T68. I attached the diagram to this page for you to check out and compare to your setup to see if the valve will fit. How tight of a fit do you think it will be?
(click to enlarge)
Product Page this Question was Asked From
Double RV Waste Valves - Heel Inlet - Rotating - 3" Hub and 1-1/2" Spigot
- RV Waste Valves
- Inlet Tee
- Double Waste Valve
- 1-1/2 Inch Valve Body
- 3 Inch Valve Body
- Manual
- 1-1/2 Inch Spigot
- 3 Inch Hub
- Rotating Valve
- Valterra
more information >
Continue Researching
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: Direct Replacement For A Bristol Double Hub V93B15
- Q&A: How are RV Sewer Lines Typically Sealed to Each Other and Can they be Separated
- Q&A: Rubber Grommet Connector Between Black Water Tanks and Waste Valve.
- Q&A: Recommended Replacement For A LaSalle Bristol V93B1 RV Sewer Fitting
- Q&A: Replacement for Bristol V93B15 Waste Valve
- Q&A: Are Valterra And LaSalle Bristol RV Waste Gate Valves Interchangeable