How Does the Chrome Cover # A45CGB Install Over Rubber Grommets
Updated 07/28/2014 | Published 07/24/2014
Products Featured in This Question
Question:
How does this chrome cover install over the rubber grommet, or does it install with just the light and no grommet? It looks like the screw holes would leave the screws going into the rubber grommet - is this what is intended?
asked by: Steve
Helpful Expert Reply:
I spoke with my contact at Optronics and she said you will need the 4" grommet, part # A45GB, to flush mount your 4" lights. The grommet gives shock mount protection that will extend the life of your lamp. The chrome cover, part # A45CGB, is designed to be screwed into the grommet part by the two screws which are included.
The 4" grommet requires a 4-1/2 inch diameter mounting hole. You may also need a wiring harness like # A47PB.
Product Page this Question was Asked From
Chrome Trim RIng for Optronics 4" Round Grommet Mount Lights
- Accessories and Parts
- Trailer Lights
- Light Trim
- Chrome
- Optronics
more information >
Continue Researching
- Q&A: Dimensions Of B&W Gooseneck Turnover Ball
- Q&A: Replacement Motor for Kwikee Motor Assembly 214-1009
- Q&A: Replacement Motor 1101422 / 214-1001 and Gear Box for Kwikee Electric RV Steps
- Q&A: Installing Brake Controller on 2007 Chevy Avalanche
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Replacement Drum and Cable for Trailer Ramp
- Q&A: No Trailer Connection on Tekonsha P3 Brake Controller 90195 on a 2000 Toyota Tundra
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Article: RV Sway Control, Stabilization, and Suspension Enhancement