Socket Size that is Between 3/4 inch and 11/16 inch
Updated 07/24/2014 | Published 07/23/2014
Question:
2001 F350 existing Ford acorn bumper nuts: Seems like 3/4 is too big and 11/16 is too small. Is it an 18mm or 23/32? Either way, I will have to go to the store.
asked by: Fred
0
Expert Reply:
A 3/4 inch socket is right at 19 mm and a 11/16 socket is right at 17.5 mm. An 18 mm socket would be right in the middle between the two and should work well for you.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 500 lbs Vert Load
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Pollak Starter Solenoid - SPST - Off-On - 12 Volt - 200 Amp - Intermittent Duty - Short Case
- Shop: Ram Gooseneck Coupler - Topwind - 7" Adjustment - Square - 2-5/16" Ball - 30K
- Shop: Flexco Manual Pull-Out Step for RVs - Single - 3" Drop/Rise - 21" Wide - 300 lbs
- Shop: Trailer Wiring
- Shop: Square 2-Speed Jack - Drop Leg w/ Spring Return - Weld On - Sidewind - 25K
- Shop: Nerf Bars - Running Boards
- Shop: Vehicle Seat Covers
- Search Results: 154r
- Search Results: a~91gb
- Search Results: peterson 421r
- Search Results: stl~43rb
- Search Results: lpl41cb
- Shop: Dexstar Steel Spoke Trailer Wheel - 16" x 6" Rim - 6 on 5-1/2 - White Powder Coat
- Shop: Optronics LED Trailer Utility Light - Submersible - 10 Diodes - Round - Clear Lens
- Shop: Dexstar Steel Spoke Trailer Wheel - 15" x 6" Rim - 6 on 5-1/2 - White Powder Coat
- Search Results: coupler repair kit
- Search Results: pintle eye
- Shop: Trailer Hitch
- Video: Installation Guide for the Curt T-Connector Vehicle Wiring Harness - 2023 Jeep Wrangler 4xe
- Video: Install: Curt Trailer Hitch Receiver on a 2024 Jeep Wrangler
- Video: All You Need to Know About the Dexter Trailer Springs Over-Under Conversion Kit
- Q&A: What is the Difference Between Double Eye Leaf Springs and Slipper Leaf Springs
- Q&A: Proper Way to Tighten Trailer Spindle of Castle Nut
- Q&A: Recommended Front Hitch for a 2025 Chevy Silverado 2500 w/ the Most Clearance Past the Hitch Pin
- Q&A: Can I Swap My Reese Sidewinder for the MORryde GooseTech 5th Wheel to Gooseneck Pin Box?
- Q&A: Front Mount Trailer Hitch Receiver For 2001 Ford F-350 Without Having To Remove Front Bumper
- Q&A: Comparison Between Draw-Tite # 65022 and Curt # 31114 Front Mount Receivers for 1999 Ford F250
- Q&A: Front Mount Hitch Fit for a 2005 Ford F-350 Super Duty
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams