Troubleshooting Lippert Auto Level Jacks Pausing and Clicking when Retracting

Updated 08/03/2026 | Published 07/14/2026

Question:

I have a2013 heartland landmark with lippert auto level when i start putting up my jacks they stop every littile bit i have to wait about 30 sconds and you here a,click then the jacks go up and then they stop and wait 30 sconds antd they go up again

asked by: Ronald F

Expert Reply:

Hi Ronald,

From what you're describing with the jacks stopping and restarting after about 30 seconds, it sounds like the circuit breaker that protects the hydraulic pump is cooling down because it has too much electricity flowing through it. The clicking sounds you're hearing is a strong indicator that's what's happening. There are a few different things you can check to find the cause: low battery voltage can cause the pump to overload and stop until the breaker resets, so check that they are fully charged and stay above 12V while retracting.

If the circuit breaker is weak or failing, you can replace it by following the power wire from the pump to the auto-resetting breaker near the battery box on the frame. Older campers use 50-amp or 80-amp breakers that can weaken over time, so replacing it is a common fix. Also check that the hydraulic pump has enough fluid, and that the battery terminals and grounds to the hydraulic pump and solenoid aren't loose or corroded.

How long has this issue with the jacks pausing been happening for?

expert reply by: Claire H

Robert

7/17/2026

Ronald: I had problems with my jacks so I replaced it with a new controller that I purchased from etrailer and installed it and it worked great. Come to find out that my old controller wasn't bad at all, you are able to reset the controller by holding down a couple of buttons at the same time. You'll have to read the owners manual because I don't remember exactly the steps but just wanted you to know that if your controller ever doesn't work at all, make sure you try to reset it according to the instructions in the manual. if I had known that it would have saved me having to buy an expensive new one. Best of luck. Robert

Claire H.

7/20/2026

@Robert I'm sorry replacing your controller wasn't necessary to get your system fixed. It's always super helpful to hear what's worked for others so we can help troubleshoot this issue in the future.

Fred S.

7/17/2026

The replacement board was purchased 07/30/2025 and installed upon receipt. The board, altho pricy, is worth getting rid of the hit or miss operation problems. Thanks again for the support.

Claire H.

7/20/2026

@FredS Glad to hear the new board took care of those hit-or-miss issues. It may not be the cheapest replacement, but having everything work reliably again is definitely worth it. Thanks for sharing your experience!

Ronald F.

8/3/2026

About a year I thought it might, be the presher switch.

Claire H.

8/3/2026

@RonaldF An issue with the pressure switch usually shows up when the hydraulic system reaches maximum pressure, like when extending the jacks to level or trailer. Since your jacks are retracting and repeatedly stopping, clicking, and then continuing it points more towards an electrical or motor issue.