Will a Class IV Ball Mount Fit 12 Inch Combo Bar # E-11
Updated 07/14/2014 | Published 07/12/2014
Question:
Hi. Can a Class IV Ball Mount Work with the E-11 Receiver Tube?
asked by: Ansari
1
Helpful Expert Reply:
A Class IV trailer hitch receiver should still have a 2 inch square opening so a Class IV ball mount would work in combo bar # E-11. The combo bar does not have a rating so the entire fabricated hitch would need to be confirmed to have the capacity to match or exceed the ball mount you are using by whomever is fabricating it.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Combo Bar 12" with 2" Trailer Hitch Receiver - Unpainted
- Hitch Fabrication Parts
- Receiver Tube
- 12 Inch Long
- Raw Finish
- Fits 2 Inch Hitch
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Curt Trailer Hitch Fit If I Remove the OEM Hitch Off of My 2020 Chevy Silverado 3500
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Wedge for Curt A20 With Reese 5th Airborne Sidewinder
- Q&A: Recommended Trailer Hitch and Cargo Carrier for a Grand Design Momentum Toy Hualer
- Q&A: Replacement for Gabriel Shock Model 610712
- Q&A: Can the Replacement Atwood Master Cylinder 85736 Still Be Obtained
- Q&A: Replacement Actuator for an Older Atwood 85736
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: Hyk Outdoors Teardrop Campers: Happy Camping Without the Hassle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Where to Position the Trailer Axle?