What Size Hole Drilled to Install the Side Marker Light Part # MC57AB with Round Grommet # A55GB
Published 07/01/2014
Products Featured in This Question
Question:
What size rubber grommet do I need for a 2inch marker/ running light? the metal is 3/8inch thick. What Im really trying to find out is the size hole I need to cut into my metal.
asked by: Quintin B
0
Product Page this Question was Asked From
Optronics Trailer Clearance or Side Marker Light - Submersible - Incandescent - Round - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 2-1/2 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Best 7-Way Wiring Harness For 2017 Honda Pilot
- Q&A: Bearing Replacement Recommendation for Timken 07100
- Q&A: Foot Pedal Replacement For A Dometic 310
- Q&A: Looking for Replacement Slam Latch for RV
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: What Material Is The Dexter Swing-Away Coupler Made Out Of
- Q&A: Is There a Trailer Wheel with a 5 on 4-1/4 inch Bolt Pattern
- Q&A: When Braking, Trailer Pulls Hard to One Side and Causes Sway
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Raise Your Travel Trailer Height
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Troubleshooting Brake Controller Installations