Where to Plug in a Curt Trailer Brake Controller on a 2007 Ford-F-250 XL
Updated 07/01/2014 | Published 06/29/2014 >
Question:
Where does a brake controller plug into a 2007 Ford F-250 XL built in 2006?
asked by: Katie E
0
Expert Reply:
Using the Curt brake controller wiring harness # C51372 you will plug it in at the factory connection point. The built-in brake control wiring harness is located behind the dashboard. To reach the connector, remove the storage pocket that is built into the center of your dash, just above the ashtray. Once you have removed the pocket, you will see the gray, 4-pin connector that mates with the adapter.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Idler Hubs for a EZ loader Oil Bath Hub Assembly
- Q&A: Replacement Tail Lights For Karavan 6' x 12' Single Axle Trailer
- Q&A: Trailer Hub Dust Cap with a 2.125" Outside Diameter
- Q&A: Replacing Older Tie Down Engineering 46210 and 46845 Trailer Hubs
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Wheel Bolt for Lippert 122096 Hub and Drum Assembly
- Q&A: Plug-In Adapter Needed to Install Brake Controller In 1998 Ford F-250
- Q&A: Curt Brake Controller Wiring Harness for 2007 Ford F-350

