Mounting Dimensions for the Butterfly Vent # PLR24-002
Updated 01/27/2026 | Published 01/12/2026
Question:
I am looking to use the PLR24-002 vent in a utility body construction and would like the 3D CAD data or mounting information to be able to put the cutouts in the sheetmetal.
asked by: Kayla H
0
Expert Reply:
Hey Kayla, we don't have any CAD drawings we can provide for the Butterfly Vent and Gasket Kit part # PLR24-002 but the mounting holes will be 6-1/2 inches apart on center across the diameter of the vent. The hole size you'd want to cut would be 6 inch and the overall diameter if 7-1/4 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Butterfly Vent and Gasket for Polar Roof Ventilator - Polished Stainless Steel
- RV Vents and Fans
- Vent
- Butterfly Vent
- Roof Vent
- No Fan
- Metal
- Silver
- Polar Hardware
more information >
Continue Researching
- Q&A: Wire Size Used to Install MaxxFan Deluxe Roof Vent w/12V Fan & Thermostat MA00-05100K
- Q&A: Does Sticky Residue on Roof Need to be Removed to Install Roof Membrane on RV
- Q&A: Comparing LaSalle Bristol (PVC) And Alpha Systems (TPO) Replacement Roof Membranes
- Q&A: Is There a 12 Volt Male End Wire For MaxxFan Dome MA00-03812B
- Q&A: Recommended Trailer Wiring To Charge Battery And Use Solar Panels
- Q&A: What RV Roof Vent Lid Material Would Hold Up Best Over Time
- Q&A: Can Redline 2-Way Pop-Up Roof Vent # 9106-2756 be Used in Rain
- Article: Trailer Lighting Requirements
Jameson C.
1/27/2026
Hey Kayla, how did the cutouts for the Butterfly Vent and Gasket Kit turn out with those measurements? Knowing how it fit in your utility body could help others planning a similar setup.