bing tracking image
Q & A Icon

Atwood GCH10A-4E Water Heater Has No Electric Power But Works on Gas  

Updated 01/27/2026 | Published 01/11/2026

Question:

I have a 2004 Itaska Suncruiser with an atwood/dometic GCH10A-4E water heater. It stopped working on the electric side but works on gas. I tested the element and it ohms out at around 10 ohms. I tested the leads and they are getting no power. I tested the thermostats and both have zero ohms. The fuses on both the board and the link to the thermostat are good. I don’t find a relay on the back near the element. Could this possibly be the board? If so, which part number?

0

Expert Reply:

Based on what you’ve checked, the board is the likely culprit. Your element ohms out correctly, the thermostats are closed, and the fuses are good, but you’ve got no 120V making it to the element. This is a pretty common failure on these older Atwood/Dometic units. The internal relay or circuitry that feeds the electric element burns out over time, leaving electric mode dead while gas still runs fine.

That said, since the Atwood line has been discontinued for some time now we no longer offer the correct control board for your GCH10A-3E model. At this point all we can recommend is replacement of the entire system. We do have GE 10-gallon unit part # GE45FR, or you could even go tankless with the Furrion # FR93FR.

If you decide to go this route just let me know and I am happy to go over the replacement process with you in more detail.

expert reply by:
0
Jesse M
Jesse M. profile picture
Etrailer Expert

Jesse M.

1/27/2026

Hey, did you end up replacing the Atwood unit with the GE 10-gallon or the Furrion tankless water heater? Knowing which route worked best could help others dealing with the same electric-side failure. Your update could make it easier for the next person with this older setup.

Product Page this Question was Asked From